Hi, We've started using an IT8613E chip in some hardware designs, and I was planning to submit our it87 driver changes to support this new chip. IT8613 supports 4 fans, but the fans it supports are fans 2-5. One of our designs has 3 fans, with the third fan connected to FAN4; however, I'm unable to control that fan using the current driver. The reason is, in the current driver, IT87_REG_PWM[3-4] is set to 0x7f, 0xa7. But on IT8613E this should be 0x1e, 0x1f. I see that these registers were defined when adding support for IT8620E. Can anybody confirm that 0x7f, 0xa7 are correct on that chip? I'm sure they weren't just pulled out of thin air, but it seems odd that ITE would have changed only those register indexes. Assuming that those registers indexes are important for at least IT8620E, what would be the desired way to proceed with adding IT8613E support? Thanks, -Justin -- To unsubscribe from this list: send the line "unsubscribe linux-hwmon" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html