[PATCH] gpio: omap: Fix double trigger for level interrupts

[Markus Schneider-Pargmann <msp@xxxxxxxxxxxx>]

Set gpio trigger before clearing the irq status.

This patch was originally proposed by Grygorii Strashko.

Cc: Grygorii Strashko <grygorii.strashko@xxxxxx>
Reported-by: Markus Mirevik <markus.mirevik@xxxxxxxxxxxxxx>
Closes: https://lore.kernel.org/all/20220122235959.GA10737@sol/T/
Signed-off-by: Markus Schneider-Pargmann <msp@xxxxxxxxxxxx>
---
Hi everyone,

this patch helped me on the beagleboneblack to remove the mentioned
double trigger of level interrupts. This diff was proposed by Grygorii
in the thread linked in the commit message. I am not sure why this never
made it into the kernel, that's why I sending this patch. I did not
create the diff just made a patch out of it, I don't care about being
the author but I would be happy if this would get merged or some other
solution to the problem.

Thanks!

Best
Markus

 drivers/gpio/gpio-omap.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
index 76d5d87e9681..74b8fe2995e1 100644
--- a/drivers/gpio/gpio-omap.c
+++ b/drivers/gpio/gpio-omap.c
@@ -696,6 +696,9 @@ static void omap_gpio_unmask_irq(struct irq_data *d)
 	raw_spin_lock_irqsave(&bank->lock, flags);
 	omap_set_gpio_irqenable(bank, offset, 1);
 
+	if (trigger)
+		omap_set_gpio_triggering(bank, offset, trigger);
+
 	/*
 	 * For level-triggered GPIOs, clearing must be done after the source
 	 * is cleared, thus after the handler has run. OMAP4 needs this done
@@ -705,9 +708,6 @@ static void omap_gpio_unmask_irq(struct irq_data *d)
 	    trigger & (IRQ_TYPE_LEVEL_HIGH | IRQ_TYPE_LEVEL_LOW))
 		omap_clear_gpio_irqstatus(bank, offset);
 
-	if (trigger)
-		omap_set_gpio_triggering(bank, offset, trigger);
-
 	raw_spin_unlock_irqrestore(&bank->lock, flags);
 }
 
-- 
2.43.0