Re: [PATCH 01/25] clk: meson: a1: restrict an amount of 'hifi_pll' params

[Jan Dakinevich <jan.dakinevich@xxxxxxxxxxxxxxxxx>]

On 3/15/24 11:58, Jerome Brunet wrote:
> 
> On Fri 15 Mar 2024 at 02:21, Jan Dakinevich <jan.dakinevich@xxxxxxxxxxxxxxxxx> wrote:
> 
>> Existing values were insufficient to produce accurate clock for audio
>> devices. New values are safe and most suitable to produce 48000Hz sample
>> rate.
> 
> The hifi pll is not about 48k only. I see no reason to restrict the PLL
> to a single setting.
> > You've provided no justification why the PLL driver can't reach the same
> setting for 48k. The setting below is just the crude part. the fine
> tuning is done done with the frac parameter so I doubt this provides a
> more accurate rate.
> 

You are right, it is not about 48k only. However, there are two issues.

First, indeed, I could just extend the range of multipliers to 1..255.
But I am unsure if hifi_pll is able to handle whole range of
mulptipliers. The value 128 is taken from Amlogic's branch, and I am
pretty sure that it works.

Second, unfortunately frac parameter currently doesn't work. When frac
is used enabling of hifi_pll fails in meson_clk_pll_wait_lock(). I see
it when try to use 44100Hz and multipliers' range is set to 1..255. So,
support of other rates than 48k requires extra effort.

>>
>> Signed-off-by: Jan Dakinevich <jan.dakinevich@xxxxxxxxxxxxxxxxx>
>> ---
>>  drivers/clk/meson/a1-pll.c | 8 ++++----
>>  1 file changed, 4 insertions(+), 4 deletions(-)
>>
>> diff --git a/drivers/clk/meson/a1-pll.c b/drivers/clk/meson/a1-pll.c
>> index 4325e8a6a3ef..00e06d03445b 100644
>> --- a/drivers/clk/meson/a1-pll.c
>> +++ b/drivers/clk/meson/a1-pll.c
>> @@ -74,9 +74,9 @@ static struct clk_regmap fixed_pll = {
>>  	},
>>  };
>>  
>> -static const struct pll_mult_range hifi_pll_mult_range = {
>> -	.min = 32,
>> -	.max = 64,
>> +static const struct pll_params_table hifi_pll_params_table[] = {
>> +	PLL_PARAMS(128, 5),
>> +	{ },
>>  };
>>  
>>  static const struct reg_sequence hifi_init_regs[] = {
>> @@ -124,7 +124,7 @@ static struct clk_regmap hifi_pll = {
>>  			.shift   = 6,
>>  			.width   = 1,
>>  		},
>> -		.range = &hifi_pll_mult_range,
>> +		.table = hifi_pll_params_table,
>>  		.init_regs = hifi_init_regs,
>>  		.init_count = ARRAY_SIZE(hifi_init_regs),
>>  	},
> 
> 

-- 
Best regards
Jan Dakinevich