[PATCH 2/2] regulator: gpio: Correct default GPIO state to LOW

[Geert Uytterhoeven <geert+renesas@xxxxxxxxx>]

According to the GPIO regulator DT bindings[1], the default GPIO state
is LOW.  However, the driver defaults to HIGH.

Before the conversion to descriptors in commit d6cd33ad71029a3f
("regulator: gpio: Convert to use descriptors"), the default state used
by the driver was rather ill-defined, too:
  - If the "gpio-states" property was missing or empty, the default was
    low, matching the bindings.
  - If the "gpio-states" property was present, the default for missing
    entries was the value of the last present entry.

Fix this by making the driver adhere to the DT bindings, i.e. default to
LOW.

[1] Documentation/devicetree/bindings/regulator/gpio-regulator.yaml

Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
---
I have no idea if this has any impact.
I guess most/all DTS files have proper gpios-states properties?
---
 drivers/regulator/gpio-regulator.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/regulator/gpio-regulator.c b/drivers/regulator/gpio-regulator.c
index 65927fa2ef161cda..5dfed8bae0c4cfdc 100644
--- a/drivers/regulator/gpio-regulator.c
+++ b/drivers/regulator/gpio-regulator.c
@@ -176,9 +176,9 @@ of_get_gpio_regulator_config(struct device *dev, struct device_node *np,
 			ret = of_property_read_u32_index(np, "gpios-states", i,
 							 &val);
 
-			/* Default to high per specification */
+			/* Default to low per specification */
 			if (ret)
-				config->gflags[i] = GPIOD_OUT_HIGH;
+				config->gflags[i] = GPIOD_OUT_LOW;
 			else
 				config->gflags[i] =
 					val ? GPIOD_OUT_HIGH : GPIOD_OUT_LOW;
-- 
2.34.1