Re: [PATCH V3 2/2] pwm: Add GPIO PWM driver

[Krzysztof Kozlowski <krzk@xxxxxxxxxx>]

On 28/01/2024 17:36, Stefan Wahren wrote:
> From: Vincent Whitchurch <vincent.whitchurch@xxxxxxxx>
> 
> Add a software PWM which toggles a GPIO from a high-resolution timer.
> 
> This will naturally not be as accurate or as efficient as a hardware
> PWM, but it is useful in some cases.  I have for example used it for
> evaluating LED brightness handling (via leds-pwm) on a board where the
> LED was just hooked up to a GPIO, and for a simple verification of the
> timer frequency on another platform.
> 

...

> +
> +static struct platform_driver pwm_gpio_driver = {
> +	.driver = {
> +		.name = "pwm-gpio",
> +		.of_match_table = pwm_gpio_dt_ids,
> +	},
> +	.probe = pwm_gpio_probe,
> +	.remove_new = pwm_gpio_remove,
> +};
> +module_platform_driver(pwm_gpio_driver);
> +
> +MODULE_DESCRIPTION("PWM GPIO driver");
> +MODULE_ALIAS("platform:pwm-gpio");

You should not need MODULE_ALIAS() in normal cases. If you need it,
usually it means your device ID table is wrong (e.g. misses either
entries or MODULE_DEVICE_TABLE()). MODULE_ALIAS() is not a substitute
for incomplete ID table.


Best regards,
Krzysztof