[PATCH 07/14] pinctrl: renesas: rzg2l: Add support to select power source for Ethernet pins

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx>

For Ethernet pins GPIO controller available on RZ/G3S (but also on RZ/G2L)
allows setting the power source. Based on the interface b/w Ethernet
controller and Ethernet PHY and board design specific power source need to
be selected. The GPIO controller allow 1.8V, 2.5V and 3.3V power source
selection for Ethernet pins and this could be selected though ETHX_POC
registers (X={0, 1}).

Commit adjust the driver to support this and does proper instantiation
for RZ/G3S and RZ/G2L SoC. On RZ/G2L only get operation has been tested
at the moment.

Signed-off-by: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx>
---
 drivers/pinctrl/renesas/pinctrl-rzg2l.c | 34 +++++++++++++++++++++++--
 1 file changed, 32 insertions(+), 2 deletions(-)

diff --git a/drivers/pinctrl/renesas/pinctrl-rzg2l.c b/drivers/pinctrl/renesas/pinctrl-rzg2l.c
index 819698dacef0..1401bb215686 100644
--- a/drivers/pinctrl/renesas/pinctrl-rzg2l.c
+++ b/drivers/pinctrl/renesas/pinctrl-rzg2l.c
@@ -107,8 +107,10 @@
 #define IEN(off)		(0x1800 + (off) * 8)
 #define ISEL(off)		(0x2C00 + (off) * 8)
 #define SD_CH(off, ch)		((off) + (ch) * 4)
+#define ETH_POC(off, ch)	((off) + (ch) * 4)
 #define QSPI			(0x3008)
 
+#define PVDD_2500		2	/* I/O domain voltage 2.5V */
 #define PVDD_1800		1	/* I/O domain voltage <= 1.8V */
 #define PVDD_3300		0	/* I/O domain voltage >= 3.3V */
 
@@ -135,10 +137,12 @@
  * struct rzg2l_register_offsets - specific register offsets
  * @pwpr: PWPR register offset
  * @sd_ch: SD_CH register offset
+ * @eth_poc: ETH_POC register offset
  */
 struct rzg2l_register_offsets {
 	u16 pwpr;
 	u16 sd_ch;
+	u16 eth_poc;
 };
 
 /**
@@ -604,6 +608,10 @@ static int rzg2l_caps_to_pwr_reg(const struct rzg2l_register_offsets *regs, u32
 		return SD_CH(regs->sd_ch, 0);
 	if (caps & PIN_CFG_IO_VMC_SD1)
 		return SD_CH(regs->sd_ch, 1);
+	if (caps & PIN_CFG_IO_VMC_ETH0)
+		return ETH_POC(regs->eth_poc, 0);
+	if (caps & PIN_CFG_IO_VMC_ETH1)
+		return ETH_POC(regs->eth_poc, 1);
 	if (caps & PIN_CFG_IO_VMC_QSPI)
 		return QSPI;
 
@@ -615,6 +623,7 @@ static int rzg2l_get_power_source(struct rzg2l_pinctrl *pctrl, u32 pin, u32 caps
 	const struct rzg2l_hwcfg *hwcfg = pctrl->data->hwcfg;
 	const struct rzg2l_register_offsets *regs = &hwcfg->regs;
 	int pwr_reg;
+	u32 val;
 
 	if (caps & PIN_CFG_SOFT_PS)
 		return pctrl->settings[pin].power_source;
@@ -623,7 +632,16 @@ static int rzg2l_get_power_source(struct rzg2l_pinctrl *pctrl, u32 pin, u32 caps
 	if (pwr_reg < 0)
 		return pwr_reg;
 
-	return (readl(pctrl->base + pwr_reg) & PVDD_MASK) ? 1800 : 3300;
+	val = readl(pctrl->base + pwr_reg);
+	if (val == PVDD_1800)
+		return 1800;
+	if (val == PVDD_2500)
+		return 2500;
+	if (val == PVDD_3300)
+		return 3300;
+
+	/* Should not happen. */
+	return -EINVAL;
 }
 
 static int rzg2l_set_power_source(struct rzg2l_pinctrl *pctrl, u32 pin, u32 caps, u32 ps)
@@ -631,17 +649,27 @@ static int rzg2l_set_power_source(struct rzg2l_pinctrl *pctrl, u32 pin, u32 caps
 	const struct rzg2l_hwcfg *hwcfg = pctrl->data->hwcfg;
 	const struct rzg2l_register_offsets *regs = &hwcfg->regs;
 	int pwr_reg;
+	u32 val;
 
 	if (caps & PIN_CFG_SOFT_PS) {
 		pctrl->settings[pin].power_source = ps;
 		return 0;
 	}
 
+	if (ps == 1800)
+		val = PVDD_1800;
+	else if (ps == 2500)
+		val = PVDD_2500;
+	else if (ps == 3300)
+		val = PVDD_3300;
+	else
+		return -EINVAL;
+
 	pwr_reg = rzg2l_caps_to_pwr_reg(regs, caps);
 	if (pwr_reg < 0)
 		return pwr_reg;
 
-	writel((ps == 1800) ? PVDD_1800 : PVDD_3300, pctrl->base + pwr_reg);
+	writel(val, pctrl->base + pwr_reg);
 	pctrl->settings[pin].power_source = ps;
 
 	return 0;
@@ -1891,6 +1919,7 @@ static const struct rzg2l_hwcfg rzg2l_hwcfg = {
 	.regs = {
 		.pwpr = 0x3014,
 		.sd_ch = 0x3000,
+		.eth_poc = 0x300c,
 	},
 	.iolh_groupa_ua = {
 		/* 3v3 power source */
@@ -1903,6 +1932,7 @@ static const struct rzg2l_hwcfg rzg3s_hwcfg = {
 	.regs = {
 		.pwpr = 0x3000,
 		.sd_ch = 0x3004,
+		.eth_poc = 0x3010,
 	},
 	.iolh_groupa_ua = {
 		/* 1v8 power source */
-- 
2.39.2





[Index of Archives]     [Linux SPI]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux