Re: [PATCH v6 1/2] dt-binding: pinctrl: Add NPCM8XX pinctrl and GPIO documentation

[Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>]

On 27/08/2023 22:36, Tomer Maimon wrote:
> Added device tree binding documentation for Nuvoton Arbel BMC NPCM8XX
> pinmux and GPIO controller.
> 
> Signed-off-by: Tomer Maimon <tmaimon77@xxxxxxxxx>
> Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
> ---


> +  '^pin':
> +    $ref: pincfg-node.yaml#
> +
> +    properties:
> +      pins:
> +        description:
> +          A list of pins to configure in certain ways, such as enabling
> +          debouncing

What pin names are allowed?

> +
> +      bias-disable: true
> +
> +      bias-pull-up: true
> +
> +      bias-pull-down: true
> +
> +      input-enable: true
> +
> +      output-low: true
> +
> +      output-high: true
> +
> +      drive-push-pull: true
> +
> +      drive-open-drain: true
> +
> +      input-debounce:
> +        description:
> +          Debouncing periods in microseconds, one period per interrupt
> +          bank found in the controller
> +        $ref: /schemas/types.yaml#/definitions/uint32-array
> +        minItems: 1
> +        maxItems: 4
> +
> +      slew-rate:
> +        description: |
> +          0: Low rate
> +          1: High rate
> +        $ref: /schemas/types.yaml#/definitions/uint32
> +        enum: [0, 1]
> +
> +      drive-strength:
> +        enum: [ 0, 1, 2, 4, 8, 12 ]
> +
> +    additionalProperties: false
> +
> +allOf:
> +  - $ref: pinctrl.yaml#
> +
> +required:
> +  - compatible
> +  - ranges
> +  - '#address-cells'
> +  - '#size-cells'
> +  - nuvoton,sysgcr
> +
> +additionalProperties: false
> +
> +examples:
> +  - |
> +    #include <dt-bindings/interrupt-controller/arm-gic.h>
> +    #include <dt-bindings/gpio/gpio.h>
> +
> +    soc {
> +      #address-cells = <2>;
> +      #size-cells = <2>;
> +
> +      pinctrl: pinctrl@f0800260 {

Nothing improved here. Test your DTS. This is being reported - I checked.

> +        compatible = "nuvoton,npcm845-pinctrl";
> +        ranges = <0x0 0x0 0xf0010000 0x8000>;
> +        #address-cells = <1>;
> +        #size-cells = <1>;
> +        nuvoton,sysgcr = <&gcr>;
> +
> +        gpio0: gpio@0 {
> +          gpio-controller;
> +          #gpio-cells = <2>;
> +          reg = <0x0 0xB0>;

Keep lowercase hex.


Best regards,
Krzysztof