Re: [PATCH net-next v9 2/9] i2c: designware: Add driver support for Wangxun 10Gb NIC

[Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>]

On Wed, May 24, 2023 at 05:17:15PM +0800, Jiawen Wu wrote:
> Wangxun 10Gb ethernet chip is connected to Designware I2C, to communicate
> with SFP.
> 
> Introduce the property "wx,i2c-snps-model" to match device data for Wangxun
> in software node case. Since IO resource was mapped on the ethernet driver,
> add a model quirk to get regmap from parent device.
> 
> The exists IP limitations are dealt as workarounds:
> - IP does not support interrupt mode, it works on polling mode.
> - Additionally set FIFO depth address the chip issue.

Looks better, thank you!
My comments below.

...

> +	if (device_property_present(&pdev->dev, "wx,i2c-snps-model"))

Assuming people are fine with this, I have no objection on the name.

> +		dev->flags |= MODEL_WANGXUN_SP;

You probably has to clear the model in dev_flags, but here still a question
which one should have a priority.

-- 
With Best Regards,
Andy Shevchenko