Re: [PATCH 2/5] gpio: Add support for Intel LJCA USB GPIO driver

["Ye, Xiang" <xiang.ye@xxxxxxxxx>]

Hi Walleij,

Thanks for the review.

On Fri, Feb 24, 2023 at 11:48:08AM +0100, Linus Walleij wrote:
> Hi Ye,
> 
> thanks for your patch!
> 
> I think your colleague Andy Shevchenko will provide the most detailed
> and deep feedback, but here are some things I spotted immediately:
> 
> On Sun, Feb 19, 2023 at 7:31 PM Ye Xiang <xiang.ye@xxxxxxxxx> wrote:
> 
> > This patch implements the GPIO function of Intel USB-I2C/GPIO/SPI adapter
> > device named "La Jolla Cove Adapter" (LJCA). It communicate with LJCA
> > GPIO module with specific protocol through interfaces exported by LJCA USB
> > driver.
> >
> > Signed-off-by: Ye Xiang <xiang.ye@xxxxxxxxx>
> (...)
> 
> > +config GPIO_LJCA
> > +       tristate "INTEL La Jolla Cove Adapter GPIO support"
> > +       depends on MFD_LJCA
> 
> I would add
> 
>    default MFD_LJCA
> 
> so if you activate the MFD you get this subdriver by default
> as module or built-in depending on what the MFD is built
> as.
> 
> (Same goes for the other subdrivers I guess)
Agree, I will add "default MFD_LJCA" on all the LJCA subdrivers.
> 
> In addition you need:
> 
> select GPIOLIB_IRQCHIP
> 
> since you use this facility.
> 
> > +static struct irq_chip ljca_gpio_irqchip = {
> 
> static const ...
Yes, I will add "select GPIOLIB_IRQCHIP" and use "static const" here.
> 
> > +       .name = "ljca-irq",
> > +       .irq_mask = ljca_irq_mask,
> > +       .irq_unmask = ljca_irq_unmask,
> > +       .irq_set_type = ljca_irq_set_type,
> > +       .irq_bus_lock = ljca_irq_bus_lock,
> > +       .irq_bus_sync_unlock = ljca_irq_bus_unlock,
> > +       .flags = IRQCHIP_IMMUTABLE,
> > +       GPIOCHIP_IRQ_RESOURCE_HELPERS,
> > +};
> 
> Yours,
> Linus Walleij

Thanks
Ye Xiang