[PATCH] pinctrl: rockchip: fix reading pull type on rk3568

[Jonas Karlman <jonas@xxxxxxxxx>]

When reading pinconf-pins from debugfs it fails to get the configured pull
type on RK3568, "unsupported pinctrl type" error messages is also reported.

Fix this by adding support for RK3568 in rockchip_get_pull, including a
reverse of the pull-up value swap applied in rockchip_set_pull so that
pull-up is correctly reported in pinconf-pins.
Also update the workaround comment to reflect affected pins, GPIO0_D3-D6.

Fixes: c0dadc0e47a8 ("pinctrl: rockchip: add support for rk3568")
Signed-off-by: Jonas Karlman <jonas@xxxxxxxxx>
---
 drivers/pinctrl/pinctrl-rockchip.c | 11 ++++++++++-
 1 file changed, 10 insertions(+), 1 deletion(-)

diff --git a/drivers/pinctrl/pinctrl-rockchip.c b/drivers/pinctrl/pinctrl-rockchip.c
index 849d5fa2a362..5eeac92f610a 100644
--- a/drivers/pinctrl/pinctrl-rockchip.c
+++ b/drivers/pinctrl/pinctrl-rockchip.c
@@ -2436,10 +2436,19 @@ static int rockchip_get_pull(struct rockchip_pin_bank *bank, int pin_num)
 	case RK3308:
 	case RK3368:
 	case RK3399:
+	case RK3568:
 	case RK3588:
 		pull_type = bank->pull_type[pin_num / 8];
 		data >>= bit;
 		data &= (1 << RK3188_PULL_BITS_PER_PIN) - 1;
+		/*
+		 * In the TRM, pull-up being 1 for everything except the GPIO0_D3-D6,
+		 * where that pull up value becomes 3.
+		 */
+		if (ctrl->type == RK3568 && bank->bank_num == 0 && pin_num >= 27 && pin_num <= 30) {
+			if (data == 3)
+				data = 1;
+		}
 
 		return rockchip_pull_list[pull_type][data];
 	default:
@@ -2497,7 +2506,7 @@ static int rockchip_set_pull(struct rockchip_pin_bank *bank,
 			}
 		}
 		/*
-		 * In the TRM, pull-up being 1 for everything except the GPIO0_D0-D6,
+		 * In the TRM, pull-up being 1 for everything except the GPIO0_D3-D6,
 		 * where that pull up value becomes 3.
 		 */
 		if (ctrl->type == RK3568 && bank->bank_num == 0 && pin_num >= 27 && pin_num <= 30) {
-- 
2.39.0