On Tue, Nov 15, 2022 at 05:14:14PM +0000, Mark Brown wrote:
> On Thu, Nov 10, 2022 at 08:55:51PM -0500, William Breathitt Gray wrote:
>
> > Provide a public callback handle_mask_sync() that drivers can use when
> > they have more complex IRQ masking logic. The default implementation is
> > regmap_irq_handle_mask_sync(), used if the chip doesn't provide its own
> > callback.
>
> Can you provide examples of something that would make sense to
> open code in a driver rather than factoring out? It looks like
> this has been added due to one of the devices you're looking at
> for some reason disabling it's upstream interrupt when all of the
> downstream interrupts are masked, while weird that doesn't seem
> especally device specific.
Sure, I actually intend to use this callback for the 104-idi-48 module
as well in the v3 submission so I'll describe that situations well.
For the 104-dio-48e we have the following:
Base Address +B (Write): Enable Interrupt
Base Address +B (Read): Disable Interrupt
Base Address +F (Read/Write): Clear Interrupt
So for 104-dio-48e, any write to 0xB will enable interrupts, while any
read will disable interrupts; interrupts are with either a read or any
write to 0xF. There's no status register either so software just has to
assume that if an interrupt is raised then it was for the
104-dio-48e device.
For the 104-idi-48, we do get a status register and some basic masking
but it's broken down by banks rather than individual GPIO; there are six
8-bit banks (Port 0 Low Byte, Port 0 Mid Byte, Port 0 High Byte, Port 1
Low Byte, Port 1 Mid Byte, Port 1 High Byte):
Base Address + 0 (Read/Write): Port 0 Low Byte
Base Address + 1 (Read/Write): Port 0 Mid Byte
Base Address + 2 (Read/Write): Port 0 High Byte
Base Address + 3: N/A
Base Address + 4 (Read/Write): Port 1 Low Byte
Base Address + 5 (Read/Write): Port 1 Mid Byte
Base Address + 6 (Read/Write): Port 1 High Byte
Base Address + 7 (Read): IRQ Status Register/IRQ Clear
Bit 0-5: Respective Bank IRQ Statuses
Bit 6: IRQ Status (Active Low)
Bit 7: IRQ Enable Status
Base Address + 7 (Write): IRQ Enable/Disable
Bit 0-5: Respective Bank IRQ Enable/Disable
In this case, masking a bank will mask all 8 GPIO within that bank;
so ideally I want a way to only mask a bank when all GPIO are masked,
and unmasking when at least one is unmasked.
Are there existing ways to support these kinds of configuration in
regmap_irq?
William Breathitt Gray
Attachment:
signature.asc
Description: PGP signature
