On Thu, Nov 17, 2022 at 12:35:42PM +0000, Niyas Sait wrote: > Fixes following issues introduced in a previous commit > to clarify values for pin config pull up and down types. > > - replace spaces with tabs to be consistent with rest of the doc > - use capitalization for unit (ohms -> Ohms) Thank you! Either folded or separated Reviewed-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> > Signed-off-by: Niyas Sait <niyas.sait@xxxxxxxxxx> > --- > include/linux/pinctrl/pinconf-generic.h | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) > > diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h > index 11e7394bcc70..537064a997a5 100644 > --- a/include/linux/pinctrl/pinconf-generic.h > +++ b/include/linux/pinctrl/pinconf-generic.h > @@ -36,7 +36,7 @@ struct pinctrl_map; > * @PIN_CONFIG_BIAS_PULL_DOWN: the pin will be pulled down (usually with high > * impedance to GROUND). If the argument is != 0 pull-down is enabled, > * the value is interpreted by the driver and can be custom or an SI unit > - * such as ohms. > + * such as Ohms. > * @PIN_CONFIG_BIAS_PULL_PIN_DEFAULT: the pin will be pulled up or down based > * on embedded knowledge of the controller hardware, like current mux > * function. The pull direction and possibly strength too will normally > @@ -48,7 +48,7 @@ struct pinctrl_map; > * @PIN_CONFIG_BIAS_PULL_UP: the pin will be pulled up (usually with high > * impedance to VDD). If the argument is != 0 pull-up is enabled, > * the value is interpreted by the driver and can be custom or an SI unit > - * such as ohms. > + * such as Ohms. > * @PIN_CONFIG_DRIVE_OPEN_DRAIN: the pin will be driven with open drain (open > * collector) which means it is usually wired with other output ports > * which are then pulled up with an external resistor. Setting this > -- > 2.25.1 > -- With Best Regards, Andy Shevchenko