On Tue, Nov 15, 2022 at 6:54 PM Niyas Sait <niyas.sait@xxxxxxxxxx> wrote: > PIN_CONFIG_BIAS_PULL_DOWN and PIN_CONFIG_BIAS_PULL_UP values can > be custom or an SI unit such as ohms > > Signed-off-by: Niyas Sait <niyas.sait@xxxxxxxxxx> This patch is good as-is so I just applied it. No need to resend with the ACPI series. Yours, Linus Walleij
Re: [PATCH RFC v2 2/3] pinconf-generic: clarify pull up and pull down config values
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
- Subject: Re: [PATCH RFC v2 2/3] pinconf-generic: clarify pull up and pull down config values
- From: Linus Walleij <linus.walleij@xxxxxxxxxx>
- Date: Thu, 17 Nov 2022 10:30:37 +0100
- In-reply-to: <20221115175415.650690-3-niyas.sait@linaro.org>
- References: <20221115175415.650690-1-niyas.sait@linaro.org> <20221115175415.650690-3-niyas.sait@linaro.org>
- Follow-Ups:
- Re: [PATCH RFC v2 2/3] pinconf-generic: clarify pull up and pull down config values
- From: Andy Shevchenko
- Re: [PATCH RFC v2 2/3] pinconf-generic: clarify pull up and pull down config values
- References:
- Prev by Date: Re: [PATCH v10 1/2] pinctrl: pinctrl-loongson2: add pinctrl driver support
- Next by Date: Re: [PATCH v4 1/2] gpio: loongson: add dts and acpi support
- Previous by thread: [PATCH RFC v2 2/3] pinconf-generic: clarify pull up and pull down config values
- Next by thread: Re: [PATCH RFC v2 2/3] pinconf-generic: clarify pull up and pull down config values
- Index(es):
 |