On Thu, Nov 10, 2022 at 08:55:50PM -0500, William Breathitt Gray wrote: > If you only have reg_dat_base set, then it is input-only; if you only > have reg_set_base set, then it is output-only. Thus, we can always set > gpio_chip get_direction to gpio_regmap_get_direction and return > GPIO_LINE_DIRECTION_IN/GPIO_LINE_DIRECTION_OUT given the respective > register base addresses configuration. Seems legit to me. Have you checked if we have any gpio-regmap drivers that have something like this in their configuration already? In such cases we need to be sure they behave as expected. >From the code perspective: Reviewed-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> > Signed-off-by: William Breathitt Gray <william.gray@xxxxxxxxxx> > --- > drivers/gpio/gpio-regmap.c | 7 ++++++- > 1 file changed, 6 insertions(+), 1 deletion(-) > > diff --git a/drivers/gpio/gpio-regmap.c b/drivers/gpio/gpio-regmap.c > index 6383136cbe59..f907c9c19fce 100644 > --- a/drivers/gpio/gpio-regmap.c > +++ b/drivers/gpio/gpio-regmap.c > @@ -111,6 +111,11 @@ static int gpio_regmap_get_direction(struct gpio_chip *chip, > unsigned int base, val, reg, mask; > int invert, ret; > > + if (gpio->reg_dat_base && !gpio->reg_set_base) > + return GPIO_LINE_DIRECTION_IN; > + if (gpio->reg_set_base && !gpio->reg_dat_base) > + return GPIO_LINE_DIRECTION_OUT; > + > if (gpio->reg_dir_out_base) { > base = gpio_regmap_addr(gpio->reg_dir_out_base); > invert = 0; > @@ -265,8 +270,8 @@ struct gpio_regmap *gpio_regmap_register(const struct gpio_regmap_config *config > else if (gpio->reg_set_base) > chip->set = gpio_regmap_set; > > + chip->get_direction = gpio_regmap_get_direction; > if (gpio->reg_dir_in_base || gpio->reg_dir_out_base) { > - chip->get_direction = gpio_regmap_get_direction; > chip->direction_input = gpio_regmap_direction_input; > chip->direction_output = gpio_regmap_direction_output; > } > -- > 2.38.1 > -- With Best Regards, Andy Shevchenko