The push_pull member is always accessed under the mutex, hence no need to use atomic operations on it. Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> --- drivers/pinctrl/pinctrl-cy8c95x0.c | 15 ++++++++------- 1 file changed, 8 insertions(+), 7 deletions(-) diff --git a/drivers/pinctrl/pinctrl-cy8c95x0.c b/drivers/pinctrl/pinctrl-cy8c95x0.c index 75be06d29dc1..367a9386dfb7 100644 --- a/drivers/pinctrl/pinctrl-cy8c95x0.c +++ b/drivers/pinctrl/pinctrl-cy8c95x0.c @@ -573,7 +573,8 @@ static int cy8c95x0_gpio_direction_input(struct gpio_chip *gc, unsigned int off) ret = regmap_write_bits(chip->regmap, CY8C95X0_DRV_HIZ, bit, bit); if (ret) goto out; - clear_bit(off, chip->push_pull); + + __clear_bit(off, chip->push_pull); } out: @@ -775,27 +776,27 @@ static int cy8c95x0_gpio_set_pincfg(struct cy8c95x0_pinctrl *chip, switch (param) { case PIN_CONFIG_BIAS_PULL_UP: - clear_bit(off, chip->push_pull); + __clear_bit(off, chip->push_pull); reg = CY8C95X0_DRV_PU; break; case PIN_CONFIG_BIAS_PULL_DOWN: - clear_bit(off, chip->push_pull); + __clear_bit(off, chip->push_pull); reg = CY8C95X0_DRV_PD; break; case PIN_CONFIG_BIAS_DISABLE: - clear_bit(off, chip->push_pull); + __clear_bit(off, chip->push_pull); reg = CY8C95X0_DRV_HIZ; break; case PIN_CONFIG_DRIVE_OPEN_DRAIN: - clear_bit(off, chip->push_pull); + __clear_bit(off, chip->push_pull); reg = CY8C95X0_DRV_ODL; break; case PIN_CONFIG_DRIVE_OPEN_SOURCE: - clear_bit(off, chip->push_pull); + __clear_bit(off, chip->push_pull); reg = CY8C95X0_DRV_ODH; break; case PIN_CONFIG_DRIVE_PUSH_PULL: - set_bit(off, chip->push_pull); + __set_bit(off, chip->push_pull); reg = CY8C95X0_DRV_PP_FAST; break; case PIN_CONFIG_MODE_PWM: -- 2.35.1