[PATCH v1 1/2] gpio: realtek-otto: amend ctrl struct docs

[Sander Vanheule <sander@xxxxxxxxxxxxx>]

Commit 512c5be35223 ("gpio: realtek-otto: Support reversed port
layouts") and commit 95fa6dbe58f2 ("gpio: realtek-otto: Support per-cpu
interrupts") updated the realtek_gpio_ctrl struct with new fields, but
the associated kernel-doc comment was not updated accordingly.

Signed-off-by: Sander Vanheule <sander@xxxxxxxxxxxxx>
---
 drivers/gpio/gpio-realtek-otto.c | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/drivers/gpio/gpio-realtek-otto.c b/drivers/gpio/gpio-realtek-otto.c
index 63dcf42f7c20..a352fbfc3c28 100644
--- a/drivers/gpio/gpio-realtek-otto.c
+++ b/drivers/gpio/gpio-realtek-otto.c
@@ -43,9 +43,19 @@
  *
  * @gc: Associated gpio_chip instance
  * @base: Base address of the register block for a GPIO bank
+ * @cpumask_base: Base address of the interrupt routing registers
+ * @cpu_irq_maskable: Mask of CPUs that can be individually masked for IRQs
  * @lock: Lock for accessing the IRQ registers and values
  * @intr_mask: Mask for interrupts lines
  * @intr_type: Interrupt type selection
+ * @port_offset_u8: Get offset of an 8b port value
+ * @port_offset_u16: Get offset of a 16b port value
+ *
+ * The DIR, DATA, and ISR registers consist of four u8 port values, packed into
+ * a single 32b register. Use @port_offset_u8 to get the correct offset inside
+ * that register. The IMR register consists of four u16 port values, packed
+ * into two 32b registers. Use @port_offset_u16 to get the correct offset for
+ * the u16 value, starting from the first register.
  *
  * Because the interrupt mask register (IMR) combines the function of IRQ type
  * selection and masking, two extra values are stored. @intr_mask is used to
-- 
2.36.1