Re: [PATCH v4 12/15] pinctrl: Add AXP192 pin control driver

[Andy Shevchenko <andy.shevchenko@xxxxxxxxx>]

On Wed, Jun 29, 2022 at 4:30 PM Aidan MacDonald
<aidanmacdonald.0x0@xxxxxxxxx> wrote:
>
> The AXP192 PMIC's GPIO registers are much different from the GPIO
> registers of the AXP20x and AXP813 PMICs supported by the existing
> pinctrl-axp209 driver. It makes more sense to add a new driver for
> the AXP192, rather than add support in the existing axp20x driver.
>
> The pinctrl-axp192 driver is considerably more flexible in terms of
> register layout and should be able to support other X-Powers PMICs.
> Interrupts and pull down resistor configuration are supported too.

...

> +config PINCTRL_AXP192
> +       tristate "X-Powers AXP192 PMIC pinctrl and GPIO Support"
> +       depends on MFD_AXP20X
> +       select PINMUX
> +       select GENERIC_PINCONF
> +       select GPIOLIB
> +       help
> +         AXP PMICs provide multiple GPIOs that can be muxed for different
> +         functions. This driver bundles a pinctrl driver to select the function
> +         muxing and a GPIO driver to handle the GPIO when the GPIO function is
> +         selected.
> +         Say Y to enable pinctrl and GPIO support for the AXP192 PMIC.

What will be the module name if compiled as a module?

...

> +/**
> + * struct axp192_pctl_function - describes a function that GPIOs may have
> + *
> + * @name: Function name
> + * @muxvals: Mux values used for selecting this function, one per GPIO.
> + *           The i'th element corresponds to the i'th GPIO and is written
> + *           to the GPIO's control register field to select this function.
> + *           U8_MAX indicates that the pin does not support this function.
> + * @groups: Array of @ngroups groups listing pins supporting this function.
> + * @ngroups: Number of pin groups.
> + */
> +struct axp192_pctl_function {
> +       const char              *name;
> +       /* Mux value written to the control register to select the function (-1 if unsupported) */
> +       const u8                *muxvals;
> +       const char * const      *groups;
> +       unsigned int            ngroups;
> +};

Can it be replaced by struct function_desc?
https://elixir.bootlin.com/linux/latest/source/drivers/pinctrl/pinmux.h#L130

...

> +       ret = devm_gpiochip_add_data(dev, &pctl->chip, pctl);
> +       if (ret)
> +               dev_err_probe(dev, ret, "Failed to register GPIO chip\n");

Missed return.

-- 
With Best Regards,
Andy Shevchenko