Re: [PATCH 15/49] regmap-irq: Change the behavior of mask_writeonly

[Aidan MacDonald <aidanmacdonald.0x0@xxxxxxxxx>]

Andy Shevchenko <andy.shevchenko@xxxxxxxxx> writes:

> On Tuesday, June 21, 2022, Aidan MacDonald <aidanmacdonald.0x0@xxxxxxxxx> wrote:
>> Andy Shevchenko <andy.shevchenko@xxxxxxxxx> writes:
>>
>> > On Mon, Jun 20, 2022 at 10:08 PM Aidan MacDonald
>> > <aidanmacdonald.0x0@xxxxxxxxx> wrote:
>> >>
>> >> No drivers currently use mask_writeonly, and in its current form
>> >> it seems a bit misleading. When set, mask registers will be
>> >> updated with regmap_write_bits() instead of regmap_update_bits(),
>> >> but regmap_write_bits() still does a read-modify-write under the
>> >> hood. It's not a write-only operation.
>> >>
>> >> Performing a simple regmap_write() is probably more useful, since
>> >> it can be used for chips that have separate set & clear registers
>> >> for controlling mask bits. Such registers are normally volatile
>> >> and read as 0, so avoiding a register read minimizes bus traffic.
>> >
>> > Reading your explanations and the code, I would rather think about
>> > fixing the regmap_write_bits() to be writeonly op.
>>
>> That's impossible without special hardware support.
>>
>> > Otherwise it's unclear what's the difference between
>> > regmap_write_bits() vs. regmap_update_bits().
>>
>> This was not obvious to me either. They're the same except in how they
>> issue the low-level write op -- regmap_update_bits() will only do the
>> write if the new value differs from the current one. regmap_write_bits()
>> will always do a write, even if the new value is the same.
>
> Okay, it makes a lot of sense for W1C type of bits in the register.
> Also, “reading” might imply to restore last value from cache, no?

Maybe there needs to be some explanation of what the typical use case is
and why you'd choose write_bits() over update_bits(), because the more I
think about it the less clear it is. You're right that the read could be
served from a cache. But I'm not sure if a cache would be safe if even
one bit in the register is volatile, and I can't really see a use case
for write_bits() that doesn't involve volatile behavior of some sort.

In any event, I'm just going to drop this patch and the related driver
patches in favor of removing mask_writeonly entirely, since it looks
like it was never used, and after thinking about it I'm not sure what
I did helps much. If some driver needs write_bits() for mask registers
down the road it's not a big deal to add this back.

>> I think the problem is lack of documentation. I only figured this out
>> by reading the implementation.
>>
>> >>         if (d->chip->mask_writeonly)
>> >> -               return regmap_write_bits(d->map, reg, mask, val);
>> >> +               return regmap_write(d->map, reg, val & mask);
>> >>         else
>> >>                 return regmap_update_bits(d->map, reg, mask, val);