[PATCH] gpio: rockchip: Reset int_bothedge when changing trigger

[Samuel Holland <samuel@xxxxxxxxxxxx>]

With v2 hardware, an IRQ can be configured to trigger on both edges via
a bit in the int_bothedge register. Currently, the driver sets this bit
when changing the trigger type to IRQ_TYPE_EDGE_BOTH, but fails to reset
this bit if the trigger type is later changed to something else. This
causes spurious IRQs, and when using gpio-keys with wakeup-event-action
set to EV_ACT_(DE)ASSERTED, those IRQs translate into spurious wakeups.

Fixes: 3bcbd1a85b68 ("gpio/rockchip: support next version gpio controller")
Reported-by: Guillaume Savaton <guillaume@xxxxxxxxxxxx>
Tested-by: Guillaume Savaton <guillaume@xxxxxxxxxxxx>
Signed-off-by: Samuel Holland <samuel@xxxxxxxxxxxx>
---
 drivers/gpio/gpio-rockchip.c | 56 +++++++++++++++++++-----------------
 1 file changed, 29 insertions(+), 27 deletions(-)

diff --git a/drivers/gpio/gpio-rockchip.c b/drivers/gpio/gpio-rockchip.c
index a4c4e4584f5b..099e358d2491 100644
--- a/drivers/gpio/gpio-rockchip.c
+++ b/drivers/gpio/gpio-rockchip.c
@@ -403,65 +403,67 @@ static int rockchip_irq_set_type(struct irq_data *d, unsigned int type)
 	if (type & IRQ_TYPE_EDGE_BOTH)
 		irq_set_handler_locked(d, handle_edge_irq);
 	else
 		irq_set_handler_locked(d, handle_level_irq);
 
 	raw_spin_lock_irqsave(&bank->slock, flags);
 
 	level = rockchip_gpio_readl(bank, bank->gpio_regs->int_type);
 	polarity = rockchip_gpio_readl(bank, bank->gpio_regs->int_polarity);
 
-	switch (type) {
-	case IRQ_TYPE_EDGE_BOTH:
+	if (type == IRQ_TYPE_EDGE_BOTH) {
 		if (bank->gpio_type == GPIO_TYPE_V2) {
-			bank->toggle_edge_mode &= ~mask;
 			rockchip_gpio_writel_bit(bank, d->hwirq, 1,
 						 bank->gpio_regs->int_bothedge);
 			goto out;
 		} else {
 			bank->toggle_edge_mode |= mask;
 			level |= mask;
 
 			/*
 			 * Determine gpio state. If 1 next interrupt should be
 			 * falling otherwise rising.
 			 */
 			data = readl(bank->reg_base + bank->gpio_regs->ext_port);
 			if (data & mask)
 				polarity &= ~mask;
 			else
 				polarity |= mask;
 		}
-		break;
-	case IRQ_TYPE_EDGE_RISING:
-		bank->toggle_edge_mode &= ~mask;
-		level |= mask;
-		polarity |= mask;
-		break;
-	case IRQ_TYPE_EDGE_FALLING:
-		bank->toggle_edge_mode &= ~mask;
-		level |= mask;
-		polarity &= ~mask;
-		break;
-	case IRQ_TYPE_LEVEL_HIGH:
-		bank->toggle_edge_mode &= ~mask;
-		level &= ~mask;
-		polarity |= mask;
-		break;
-	case IRQ_TYPE_LEVEL_LOW:
-		bank->toggle_edge_mode &= ~mask;
-		level &= ~mask;
-		polarity &= ~mask;
-		break;
-	default:
-		ret = -EINVAL;
-		goto out;
+	} else {
+		if (bank->gpio_type == GPIO_TYPE_V2) {
+			rockchip_gpio_writel_bit(bank, d->hwirq, 0,
+						 bank->gpio_regs->int_bothedge);
+		} else {
+			bank->toggle_edge_mode &= ~mask;
+		}
+		switch (type) {
+		case IRQ_TYPE_EDGE_RISING:
+			level |= mask;
+			polarity |= mask;
+			break;
+		case IRQ_TYPE_EDGE_FALLING:
+			level |= mask;
+			polarity &= ~mask;
+			break;
+		case IRQ_TYPE_LEVEL_HIGH:
+			level &= ~mask;
+			polarity |= mask;
+			break;
+		case IRQ_TYPE_LEVEL_LOW:
+			level &= ~mask;
+			polarity &= ~mask;
+			break;
+		default:
+			ret = -EINVAL;
+			goto out;
+		}
 	}
 
 	rockchip_gpio_writel(bank, level, bank->gpio_regs->int_type);
 	rockchip_gpio_writel(bank, polarity, bank->gpio_regs->int_polarity);
 out:
 	raw_spin_unlock_irqrestore(&bank->slock, flags);
 
 	return ret;
 }
 
-- 
2.33.1