Re: [PATCH v5 12/13] gpio: Add support for Airoha EN7523 GPIO controller

[Andy Shevchenko <andy.shevchenko@xxxxxxxxx>]

On Tue, Nov 30, 2021 at 1:08 AM Felix Fietkau <nbd@xxxxxxxx> wrote:
>
> From: John Crispin <john@xxxxxxxxxxx>
>
> Airoha's GPIO controller on their ARM EN7523 SoCs consists of two banks of 32
> GPIOs. Each instance in DT is for an single bank.

a single

...

> +/**
> + * airoha_gpio_ctrl - Airoha GPIO driver data

> + *

Unnecessary blank line.

> + * @gc: Associated gpio_chip instance.
> + * @data: The data register.
> + * @dir0: The direction register for the lower 16 pins.
> + * @dir1: The direction register for the higher 16 pins.
> + * @output: The output enable register.
> + */

...

> +static int airoha_dir_set(struct gpio_chip *gc, unsigned int gpio,
> +                         int val, int out)
> +{
> +       struct airoha_gpio_ctrl *ctrl = gc_to_ctrl(gc);
> +       u32 dir = ioread32(ctrl->dir[gpio / 16]);
> +       u32 output = ioread32(ctrl->output);
> +       u32 mask = BIT((gpio % 16) * 2);
> +
> +       if (out) {
> +               dir |= mask;
> +               output |= BIT(gpio);
> +       } else {
> +               dir &= ~mask;
> +               output &= ~BIT(gpio);
> +       }
> +
> +       iowrite32(dir, ctrl->dir[gpio / 16]);
> +       iowrite32(output, ctrl->output);

> +       if (out)
> +               gc->set(gc, gpio, val);

Needs a fix or a comment to explain why it's fine that there is a
glitch possible.

> +       return 0;
> +}

...

> +       err = bgpio_init(&ctrl->gc, dev, 4, ctrl->data, NULL,
> +                        NULL, NULL, NULL, 0);
> +       if (err) {

> +               dev_err(dev, "unable to init generic GPIO");
> +               return err;

return dev_err_probe(...);

> +       }

-- 
With Best Regards,
Andy Shevchenko