Re: [PATCH v2 09/14] dt-bindings: interrupt-controller: Convert Broadcom STB L2 to YAML

[Rob Herring <robh@xxxxxxxxxx>]

On Mon, 06 Dec 2021 10:26:11 -0800, Florian Fainelli wrote:
> Convert the Broadcom STB L2 generic Level 2 interrupt controller Device
> Tree binding to YAML to help with validation.
> 
> Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
> ---
>  .../interrupt-controller/brcm,l2-intc.txt     | 31 ---------
>  .../interrupt-controller/brcm,l2-intc.yaml    | 64 +++++++++++++++++++
>  2 files changed, 64 insertions(+), 31 deletions(-)
>  delete mode 100644 Documentation/devicetree/bindings/interrupt-controller/brcm,l2-intc.txt
>  create mode 100644 Documentation/devicetree/bindings/interrupt-controller/brcm,l2-intc.yaml
> 

Running 'make dtbs_check' with the schema in this patch gives the
following warnings. Consider if they are expected or the schema is
incorrect. These may not be new warnings.

Note that it is not yet a requirement to have 0 warnings for dtbs_check.
This will change in the future.

Full log is available here: https://patchwork.ozlabs.org/patch/1564135


interrupt-controller@3e1000: 'interrupt-names' does not match any of the regexes: 'pinctrl-[0-9]+'
	arch/arm/boot/dts/bcm7445-bcm97445svmb.dt.yaml

interrupt-controller@7ef00100: compatible: 'oneOf' conditional failed, one must be fixed:
	arch/arm64/boot/dts/broadcom/bcm2711-rpi-400.dt.yaml
	arch/arm64/boot/dts/broadcom/bcm2711-rpi-4-b.dt.yaml
	arch/arm64/boot/dts/broadcom/bcm2711-rpi-cm4-io.dt.yaml
	arch/arm/boot/dts/bcm2711-rpi-400.dt.yaml
	arch/arm/boot/dts/bcm2711-rpi-4-b.dt.yaml
	arch/arm/boot/dts/bcm2711-rpi-cm4-io.dt.yaml