Re: [PATCH v4 12/12] gpio: Add support for Airoha EN7523 GPIO controller

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 

On Thu, Nov 25, 2021 at 12:24 PM Felix Fietkau <nbd@xxxxxxxx> wrote:
>
> From: John Crispin <john@xxxxxxxxxxx>
>
> Airoha's GPIO controller on their ARM EN7523 SoCs consists of two banks of 32
> GPIOs. Each instance in DT is for an single bank.
>
> Signed-off-by: John Crispin <john@xxxxxxxxxxx>
> Signed-off-by: Felix Fietkau <nbd@xxxxxxxx>
> ---
>  arch/arm/boot/dts/en7523-evb.dts |   8 ++
>  arch/arm/boot/dts/en7523.dtsi    |  21 +++++
>  drivers/gpio/Kconfig             |   9 ++
>  drivers/gpio/Makefile            |   1 +
>  drivers/gpio/gpio-en7523.c       | 136 +++++++++++++++++++++++++++++++
>  5 files changed, 175 insertions(+)
>  create mode 100644 drivers/gpio/gpio-en7523.c

These changes should be split into two separate patches. Other than
that the driver looks good.

>
> diff --git a/arch/arm/boot/dts/en7523-evb.dts b/arch/arm/boot/dts/en7523-evb.dts
> index af1a8dd40a41..4082bf61bd79 100644
> --- a/arch/arm/boot/dts/en7523-evb.dts
> +++ b/arch/arm/boot/dts/en7523-evb.dts
> @@ -37,3 +37,11 @@ &pcie0 {
>  &pcie1 {
>         status = "okay";
>  };
> +
> +&gpio0 {
> +       status = "okay";
> +};
> +
> +&gpio1 {
> +       status = "okay";
> +};
> diff --git a/arch/arm/boot/dts/en7523.dtsi b/arch/arm/boot/dts/en7523.dtsi
> index d9bdb51614b5..6e0275984b69 100644
> --- a/arch/arm/boot/dts/en7523.dtsi
> +++ b/arch/arm/boot/dts/en7523.dtsi
> @@ -3,6 +3,7 @@
>  #include <dt-bindings/interrupt-controller/irq.h>
>  #include <dt-bindings/interrupt-controller/arm-gic.h>
>  #include <dt-bindings/clock/en7523-clk.h>
> +#include <dt-bindings/gpio/gpio.h>
>
>  / {
>         interrupt-parent = <&gic>;
> @@ -120,6 +121,26 @@ uart1: serial@1fbf0000 {
>                 status = "okay";
>         };
>
> +       gpio0: gpio@1fbf0200 {
> +               compatible = "airoha,en7523-gpio";
> +               reg = <0x1fbf0204 0x4>,
> +                     <0x1fbf0200 0x4>,
> +                     <0x1fbf0220 0x4>,
> +                     <0x1fbf0214 0x4>;
> +               gpio-controller;
> +               #gpio-cells = <2>;
> +       };
> +
> +       gpio1: gpio@1fbf0270 {
> +               compatible = "airoha,en7523-gpio";
> +               reg = <0x1fbf0270 0x4>,
> +                     <0x1fbf0260 0x4>,
> +                     <0x1fbf0264 0x4>,
> +                     <0x1fbf0278 0x4>;
> +               gpio-controller;
> +               #gpio-cells = <2>;
> +       };
> +
>         pcie: pcie@1a140000 {
>                 compatible = "airoha,en7523-pcie", "mediatek,mt7622-pcie";
>                 device_type = "pci";
> diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
> index 072ed610f9c6..e4a34272504f 100644
> --- a/drivers/gpio/Kconfig
> +++ b/drivers/gpio/Kconfig
> @@ -247,6 +247,15 @@ config GPIO_EM
>         help
>           Say yes here to support GPIO on Renesas Emma Mobile SoCs.
>
> +config GPIO_EN7523
> +       tristate "Airoha GPIO support"
> +       depends on ARCH_AIROHA
> +       default ARCH_AIROHA
> +       select GPIO_GENERIC
> +       select GPIOLIB_IRQCHIP
> +       help
> +         Say yes here to support the GPIO controller on Airoha EN7523.
> +
>  config GPIO_EP93XX
>         def_bool y
>         depends on ARCH_EP93XX
> diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile
> index 71ee9fc2ff83..d2269ee0948e 100644
> --- a/drivers/gpio/Makefile
> +++ b/drivers/gpio/Makefile
> @@ -56,6 +56,7 @@ obj-$(CONFIG_GPIO_DLN2)                       += gpio-dln2.o
>  obj-$(CONFIG_GPIO_DWAPB)               += gpio-dwapb.o
>  obj-$(CONFIG_GPIO_EIC_SPRD)            += gpio-eic-sprd.o
>  obj-$(CONFIG_GPIO_EM)                  += gpio-em.o
> +obj-$(CONFIG_GPIO_EN7523)              += gpio-en7523.o
>  obj-$(CONFIG_GPIO_EP93XX)              += gpio-ep93xx.o
>  obj-$(CONFIG_GPIO_EXAR)                        += gpio-exar.o
>  obj-$(CONFIG_GPIO_F7188X)              += gpio-f7188x.o
> diff --git a/drivers/gpio/gpio-en7523.c b/drivers/gpio/gpio-en7523.c
> new file mode 100644
> index 000000000000..3ae0d9831d83
> --- /dev/null
> +++ b/drivers/gpio/gpio-en7523.c
> @@ -0,0 +1,136 @@
> +// SPDX-License-Identifier: GPL-2.0-only
> +
> +#include <linux/gpio/driver.h>
> +#include <linux/mod_devicetable.h>
> +#include <linux/module.h>
> +#include <linux/platform_device.h>
> +#include <linux/property.h>
> +
> +#define AIROHA_GPIO_MAX                32
> +
> +/**
> + * airoha_gpio_ctrl - Airoha GPIO driver data
> + *
> + * @gc: Associated gpio_chip instance.
> + * @data: The data register.
> + * @dir0: The direction register for the lower 16 pins.
> + * @dir1: The direction register for the lower 16 pins.
> + * @output: The output enable register.
> + */
> +struct airoha_gpio_ctrl {
> +       struct gpio_chip gc;
> +       void __iomem *data;
> +       void __iomem *dir[2];
> +       void __iomem *output;
> +};
> +
> +static struct airoha_gpio_ctrl *gc_to_ctrl(struct gpio_chip *gc)
> +{
> +       return container_of(gc, struct airoha_gpio_ctrl, gc);
> +}
> +
> +static int airoha_dir_set(struct gpio_chip *gc, unsigned int gpio,
> +                         int val, int out)
> +{
> +       struct airoha_gpio_ctrl *ctrl = gc_to_ctrl(gc);
> +       u32 dir = ioread32(ctrl->dir[gpio / 16]);
> +       u32 output = ioread32(ctrl->output);
> +       u32 mask = BIT((gpio % 16) * 2);
> +
> +       if (out) {
> +               dir |= mask;
> +               output |= BIT(gpio);
> +       } else {
> +               dir &= ~mask;
> +               output &= ~BIT(gpio);
> +       }
> +
> +       iowrite32(dir, ctrl->dir[gpio / 16]);
> +       iowrite32(output, ctrl->output);
> +
> +       if (out)
> +               gc->set(gc, gpio, val);
> +
> +       return 0;
> +}

No locking needed here? gpio-mmio uses bgpio_lock from struct
gpio_chip, maybe you should take it here too?

Bart

> +
> +static int airoha_dir_out(struct gpio_chip *gc, unsigned int gpio,
> +                         int val)
> +{
> +       return airoha_dir_set(gc, gpio, val, 1);
> +}
> +
> +static int airoha_dir_in(struct gpio_chip *gc, unsigned int gpio)
> +{
> +       return airoha_dir_set(gc, gpio, 0, 0);
> +}
> +
> +static int airoha_get_dir(struct gpio_chip *gc, unsigned int gpio)
> +{
> +       struct airoha_gpio_ctrl *ctrl = gc_to_ctrl(gc);
> +       u32 dir = ioread32(ctrl->dir[gpio / 16]);
> +       u32 mask = BIT((gpio % 16) * 2);
> +
> +       return dir & mask;
> +}
> +
> +static const struct of_device_id airoha_gpio_of_match[] = {
> +       { .compatible = "airoha,en7523-gpio" },
> +       { }
> +};
> +MODULE_DEVICE_TABLE(of, airoha_gpio_of_match);
> +
> +static int airoha_gpio_probe(struct platform_device *pdev)
> +{
> +       struct device *dev = &pdev->dev;
> +       struct airoha_gpio_ctrl *ctrl;
> +       int err;
> +
> +       ctrl = devm_kzalloc(dev, sizeof(*ctrl), GFP_KERNEL);
> +       if (!ctrl)
> +               return -ENOMEM;
> +
> +       ctrl->data = devm_platform_ioremap_resource(pdev, 0);
> +       if (IS_ERR(ctrl->data))
> +               return PTR_ERR(ctrl->data);
> +
> +       ctrl->dir[0] = devm_platform_ioremap_resource(pdev, 1);
> +       if (IS_ERR(ctrl->dir[0]))
> +               return PTR_ERR(ctrl->dir[0]);
> +
> +       ctrl->dir[1] = devm_platform_ioremap_resource(pdev, 2);
> +       if (IS_ERR(ctrl->dir[1]))
> +               return PTR_ERR(ctrl->dir[1]);
> +
> +       ctrl->output = devm_platform_ioremap_resource(pdev, 3);
> +       if (IS_ERR(ctrl->output))
> +               return PTR_ERR(ctrl->output);
> +
> +       err = bgpio_init(&ctrl->gc, dev, 4, ctrl->data, NULL,
> +                        NULL, NULL, NULL, 0);
> +       if (err) {
> +               dev_err(dev, "unable to init generic GPIO");
> +               return err;
> +       }
> +
> +       ctrl->gc.ngpio = AIROHA_GPIO_MAX;
> +       ctrl->gc.owner = THIS_MODULE;
> +       ctrl->gc.direction_output = airoha_dir_out;
> +       ctrl->gc.direction_input = airoha_dir_in;
> +       ctrl->gc.get_direction = airoha_get_dir;
> +
> +       return devm_gpiochip_add_data(dev, &ctrl->gc, ctrl);
> +}
> +
> +static struct platform_driver airoha_gpio_driver = {
> +       .driver = {
> +               .name = "airoha-gpio",
> +               .of_match_table = airoha_gpio_of_match,
> +       },
> +       .probe = airoha_gpio_probe,
> +};
> +module_platform_driver(airoha_gpio_driver);
> +
> +MODULE_DESCRIPTION("Airoha GPIO support");
> +MODULE_AUTHOR("John Crispin <john@xxxxxxxxxxx>");
> +MODULE_LICENSE("GPL v2");
> --
> 2.30.1
>
[Index of Archives]     [Linux SPI]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux