[PATCH] gpio: realtek-otto: fix GPIO line IRQ offset

[Sander Vanheule <sander@xxxxxxxxxxxxx>]

The irqchip uses one domain for all GPIO lines, so the line offset
should be determined w.r.t. the first line of the first port, not the
first line of the triggered port.

Fixes: 0d82fb1127fb ("gpio: Add Realtek Otto GPIO support")
Signed-off-by: Sander Vanheule <sander@xxxxxxxxxxxxx>
---
 drivers/gpio/gpio-realtek-otto.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/gpio/gpio-realtek-otto.c b/drivers/gpio/gpio-realtek-otto.c
index eeeb39bc171d..bd75401b549d 100644
--- a/drivers/gpio/gpio-realtek-otto.c
+++ b/drivers/gpio/gpio-realtek-otto.c
@@ -205,7 +205,7 @@ static void realtek_gpio_irq_handler(struct irq_desc *desc)
 		status = realtek_gpio_read_isr(ctrl, lines_done / 8);
 		port_pin_count = min(gc->ngpio - lines_done, 8U);
 		for_each_set_bit(offset, &status, port_pin_count)
-			generic_handle_domain_irq(gc->irq.domain, offset);
+			generic_handle_domain_irq(gc->irq.domain, offset + lines_done);
 	}
 
 	chained_irq_exit(irq_chip, desc);
-- 
2.31.1