Re: [PATCH v3 6/6] leds: Add support for RTL8231 LED scan matrix

[Andy Shevchenko <andy.shevchenko@xxxxxxxxx>]

On Mon, May 24, 2021 at 1:34 AM Sander Vanheule <sander@xxxxxxxxxxxxx> wrote:
>
> Both single and bi-color scanning modes are supported. The driver will
> verify that the addresses are valid for the current mode, before
> registering the LEDs. LEDs can be turned on, off, or toggled at one of
> six predefined rates from 40ms to 1280ms.
>
> Implements a platform device for use as a child device with RTL8231 MFD,
> and uses the parent regmap to access the required registers.

...

> +         This options enables support for using the LED scanning matrix output

option

> +         of the RTL8231 GPIO and LED expander chip.
> +         When built as a module, this module will be named leds-rtl8231.

...

> +               interval_ms = 500;

Does this deserve a #define?

...

> +       ret = fwnode_property_count_u32(fwnode, "reg");
> +       if (ret < 0)
> +               return ret;
> +       if (ret != 2)
> +               return -ENODEV;

I would say -EINVAL, but -ENODEV is similarly okay.

...

> +       int err;

ret or err? Be consistent across a single driver.

...

> +       int err;

Ditto.


-- 
With Best Regards,
Andy Shevchenko