On 3/5/21 1:24 PM, Andy Shevchenko wrote:
On Fri, Mar 05, 2021 at 01:11:39PM +0100, Marek Vasut wrote:
On 3/5/21 1:02 PM, Andy Shevchenko wrote:
On STM32MP1, the GPIO banks are subnodes of pin-controller@50002000,
see arch/arm/boot/dts/stm32mp151.dtsi. The driver for
pin-controller@50002000 is in drivers/pinctrl/stm32/pinctrl-stm32.c
and iterates over all of its DT subnodes when registering each GPIO
bank gpiochip. Each gpiochip has:
- gpio_chip.parent = dev,
where dev is the device node of the pin controller
- gpio_chip.of_node = np,
which is the OF node of the GPIO bank
Therefore, dev_fwnode(chip->parent) != of_fwnode_handle(chip.of_node),
i.e. pin-controller@50002000 != pin-controller@50002000/gpio@5000*000.
The original code behaved correctly, as it extracted the "gpio-line-names"
from of_fwnode_handle(chip.of_node) = pin-controller@50002000/gpio@5000*000.
To achieve the same behaviour, read property from the firmware node.
Fixes: 7cba1a4d5e162 ("gpiolib: generalize devprop_gpiochip_set_names() for device properties")
Reported-by: Marek Vasut <marex@xxxxxxx>
Reported-by: Roman Guskov <rguskov@xxxxxxxxxxxxxxxxxx>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
Tested-by: Marek Vasut <marex@xxxxxxx>
Reviewed-by: Marek Vasut <marex@xxxxxxx>
Thanks!
Thanks
static int devprop_gpiochip_set_names(struct gpio_chip *chip)
{
struct gpio_device *gdev = chip->gpiodev;
- struct device *dev = chip->parent;
+ struct fwnode_handle *fwnode = dev_fwnode(&gdev->dev);
You could make the order here a reverse xmas tree, but that's a nitpick.
They are dependent, can't be reordered.
Doh, you're right.
