On Mon, Jan 25, 2021 at 11:15 AM Hailong Fan <hailong.fan@xxxxxxxxxxxx> wrote: > > When flipping the polarity will be generated interrupt under certain > circumstances, but GPIO external signal has not changed. > Then, mask the interrupt before polarity setting, and clear the > unexpected interrupt after trigger type setting completed. I'd add a short note about why you remove mtk_eint_flip_edge, that is, because mtk_eint_unmask already calls it. > > Signed-off-by: Hailong Fan <hailong.fan@xxxxxxxxxxxx> > --- > [V2] > --- > drivers/pinctrl/mediatek/mtk-eint.c | 13 +++++++++++-- > 1 file changed, 11 insertions(+), 2 deletions(-) > > diff --git a/drivers/pinctrl/mediatek/mtk-eint.c b/drivers/pinctrl/mediatek/mtk-eint.c > index 22736f60c16c..0042f32c7e7e 100644 > --- a/drivers/pinctrl/mediatek/mtk-eint.c > +++ b/drivers/pinctrl/mediatek/mtk-eint.c > @@ -157,6 +157,7 @@ static void mtk_eint_ack(struct irq_data *d) > static int mtk_eint_set_type(struct irq_data *d, unsigned int type) > { > struct mtk_eint *eint = irq_data_get_irq_chip_data(d); > + bool unmasked; Well, this is true if the interrupt has been masked (or, equivalently, if we need to unmask it later). So I think either "masked" or "unmask" are better as variable names. > u32 mask = BIT(d->hwirq & 0x1f); > void __iomem *reg; > > @@ -173,6 +174,13 @@ static int mtk_eint_set_type(struct irq_data *d, unsigned int type) > else > eint->dual_edge[d->hwirq] = 0; > > + if (!mtk_eint_get_mask(eint, d->hwirq)) { > + mtk_eint_mask(d); > + unmasked = true; > + } else { > + unmasked = false; > + } > + > if (type & (IRQ_TYPE_LEVEL_LOW | IRQ_TYPE_EDGE_FALLING)) { > reg = mtk_eint_get_offset(eint, d->hwirq, eint->regs->pol_clr); > writel(mask, reg); > @@ -189,8 +197,9 @@ static int mtk_eint_set_type(struct irq_data *d, unsigned int type) > writel(mask, reg); > } > > - if (eint->dual_edge[d->hwirq]) > - mtk_eint_flip_edge(eint, d->hwirq); > + mtk_eint_ack(d); > + if (unmasked) > + mtk_eint_unmask(d); > > return 0; > } > -- > 2.18.0