Re: [PATCH v10 3/3] arm64: dts: sparx5: Add SGPIO devices

[Lars Povlsen <lars.povlsen@xxxxxxxxxxxxx>]

Andrew Lunn writes:

> On Fri, Nov 13, 2020 at 03:51:51PM +0100, Lars Povlsen wrote:
>> +             led@8 {
>> +                     label = "eth12:green";
>> +                     gpios = <&sgpio_out0 12 0 GPIO_ACTIVE_HIGH>;
>> +                     default-state = "off";
>> +             };
>> +             led@9 {
>> +                     label = "eth12:yellow";
>> +                     gpios = <&sgpio_out0 12 1 GPIO_ACTIVE_HIGH>;
>> +                     default-state = "off";
>> +             };
>
> Hi Lars
>
> I did not see these patches earlier, but i've been looking at the
> switch driver patches recently, so went digging.
>
> Can the Ethernet switch itself control these LEDs for indicating
> things like packet receive/transmit, link state, and link speed? Or
> are they purely software controlled?
>
>     Thanks
>         Andrew

Hi Andrew!

No, the SGPIO device is separate from the switch device as such. I was
planning to couple the two by means of "led events" in a later patch.

---Lars

--
Lars Povlsen,
Microchip