Re: [PATCH 3/4] USB: serial: ftdi_sio: Log the CBUS GPIO validity

[Johan Hovold <johan@xxxxxxxxxx>]

On Wed, Dec 09, 2020 at 10:35:53AM +0100, Linus Walleij wrote:
> On Mon, Dec 7, 2020 at 4:19 PM Johan Hovold <johan@xxxxxxxxxx> wrote:
> > On Mon, Dec 07, 2020 at 03:00:37PM +0000, Marc Zyngier wrote:
> > > On 2020-12-07 14:29, Johan Hovold wrote:
> > > > On Fri, Dec 04, 2020 at 04:47:38PM +0000, Marc Zyngier wrote:
> >
> > > >> +  if (!bitmap_full(valid_mask, ngpios))
> > > >> +          dev_warn_once(&port->dev, "Consider using a tool such as ftx-prog
> > > >> to enable GPIOs if required\n");
> > > >> +
> > > >
> > > > And again, this is not something that belongs in the logs of just about
> > > > every system with an attached ftdi device.
> > >
> > > Fine by me, this patch can be dropped without issue. After all,
> > > I now know how to deal with these chips.
> > >
> > > > While not possible to combine with the valid_mask approach, this is
> > > > something which we could otherwise add to the request() callback for
> > > > the
> > > > first request that fails due to the mux configuration.
> > >
> > > That was Linus' initial suggestion. But I think a consistent user
> > > API is more important than free advise in the kernel log.
> >
> > I tend to agree. So since your valid-mask approach clearly has some
> > merit in that it marks the lines in use when using the new cdev
> > interface, perhaps we should stick with that.
> 
> It sounds like we agree that this patch sans prints is acceptable.
> 
> It makes things better so let's go with that.

Sounds good.

I'm about to apply patches 2, 3 and 4 with some smaller changes like
demoting the printk messages to KERN_DEBUG and dropping the ftx-progs
warning.

> The problem for the user is that the line looks to be
> "used by the kernel" (true in some sense) but they have no
> idea what to do about it and that the ftx-prog will solve
> their hacking problem.

Right, it's not ideal, but the datasheets for these devices clearly
states that the configuration of the CBUS pins is done in EEPROM and the
vendor provides some tool to do that. Then there's a bunch of open
source implementations for the same including ftx-progs (which can only
be used for a subset of these devices).

I'd be fine with a dev_err() on the first request that fails saying that
the CBUS pin is not configured for GPIO use (perhaps even on every
request if its not something that a non-root user can trigger). But we
cannot have both that and have the line marked in-use through the
chardev interface currently.

I'm admittedly a bit torn on which is preferable.

Johan