[PATCH 3/3] devicetree: mcp23s08: Remove interrupt-controller

[Thomas Preston <thomas.preston@xxxxxxxxxxxxxxx>]

The mcp23s08 device and friends are interrupt /client/ nodes, and should
not reference the interrupt controller device tree properties
"interrupt-controller" and "interrupt-cells" [0].

Remove the confusing "interrupt-controller" and "interrupt-cells"
properties from the pinctrl-mcp23s08 devicetree bindings documentation.

[0] Documentation/devicetree/bindings/interrupt-controller/interrupts.txt

Signed-off-by: Thomas Preston <thomas.preston@xxxxxxxxxxxxxxx>
---
 .../devicetree/bindings/pinctrl/pinctrl-mcp23s08.txt      | 8 --------
 1 file changed, 8 deletions(-)

diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-mcp23s08.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-mcp23s08.txt
index 8b94aa8f5971..bb1b53030552 100644
--- a/Documentation/devicetree/bindings/pinctrl/pinctrl-mcp23s08.txt
+++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-mcp23s08.txt
@@ -43,10 +43,6 @@ Required device specific properties (only for SPI chips):
 - spi-max-frequency = The maximum frequency this chip is able to handle
 
 Optional properties:
-- #interrupt-cells : Should be two.
-  - first cell is the pin number
-  - second cell is used to specify flags.
-- interrupt-controller: Marks the device node as a interrupt controller.
 - drive-open-drain: Sets the ODR flag in the IOCON register. This configures
         the IRQ output as open drain active low.
 
@@ -72,8 +68,6 @@ gpiom1: gpio@20 {
 
         interrupt-parent = <&gpio1>;
         interrupts = <17 IRQ_TYPE_LEVEL_LOW>;
-        interrupt-controller;
-        #interrupt-cells=<2>;
         microchip,irq-mirror;
 };
 
@@ -130,8 +124,6 @@ gpio21: gpio@21 {
 	interrupt-parent = <&socgpio>;
 	interrupts = <0x17 0x8>;
 	interrupt-names = "mcp23017@21 irq";
-	interrupt-controller;
-	#interrupt-cells = <0x2>;
 	microchip,irq-mirror;
 	pinctrl-names = "default";
 	pinctrl-0 = <&i2cgpio0irq &gpio21pullups>;
-- 
2.26.2