Implement a get_multiple function for gpio-pca953x. If a driver leaves get_multiple unimplemented then gpio_chip_get_multiple() in gpiolib.c takes care of it by calling chip->get() as needed. For i2c chips this is very inefficient. For example if you do an 8-bit read then instead of a single i2c transaction there are 8 transactions reading the same byte! This has been tested with max7312 chips on a 5.2 kernel. Signed-off-by: Paul Thomas <pthomas8589@xxxxxxxxx> --- drivers/gpio/gpio-pca953x.c | 37 +++++++++++++++++++++++++++++++++++++ 1 file changed, 37 insertions(+) diff --git a/drivers/gpio/gpio-pca953x.c b/drivers/gpio/gpio-pca953x.c index 96d42f571a18..705115bde740 100644 --- a/drivers/gpio/gpio-pca953x.c +++ b/drivers/gpio/gpio-pca953x.c @@ -114,6 +114,7 @@ MODULE_DEVICE_TABLE(acpi, pca953x_acpi_ids); #define MAX_BANK 5 #define BANK_SZ 8 +#define BANK_SFT 3 /* ilog2(BANK_SZ) */ #define NBANK(chip) DIV_ROUND_UP(chip->gpio_chip.ngpio, BANK_SZ) @@ -451,6 +452,41 @@ static int pca953x_gpio_get_direction(struct gpio_chip *gc, unsigned off) return !!(reg_val & bit); } +static int pca953x_gpio_get_multiple(struct gpio_chip *gc, + unsigned long *mask, unsigned long *bits) +{ + struct pca953x_chip *chip = gpiochip_get_data(gc); + unsigned int reg_val; + int offset, value, i, ret = 0; + u8 inreg; + + /* Force offset outside the range of i so that + * at least the first relevant register is read + */ + offset = gc->ngpio; + for_each_set_bit(i, mask, gc->ngpio) { + /* whenever i goes into a new bank update inreg + * and read the register + */ + if ((offset >> BANK_SFT) != (i >> BANK_SFT)) { + offset = i; + inreg = pca953x_recalc_addr(chip, chip->regs->input, + offset, true, false); + mutex_lock(&chip->i2c_lock); + ret = regmap_read(chip->regmap, inreg, ®_val); + mutex_unlock(&chip->i2c_lock); + if (ret < 0) + return ret; + } + /* reg_val is relative to the last read byte, + * so only shift the relative bits + */ + value = (reg_val >> (i % 8)) & 0x01; + __assign_bit(i, bits, value); + } + return ret; +} + static void pca953x_gpio_set_multiple(struct gpio_chip *gc, unsigned long *mask, unsigned long *bits) { @@ -547,6 +583,7 @@ static void pca953x_setup_gpio(struct pca953x_chip *chip, int gpios) gc->get = pca953x_gpio_get_value; gc->set = pca953x_gpio_set_value; gc->get_direction = pca953x_gpio_get_direction; + gc->get_multiple = pca953x_gpio_get_multiple; gc->set_multiple = pca953x_gpio_set_multiple; gc->set_config = pca953x_gpio_set_config; gc->can_sleep = true; -- 2.17.1