On Thu, Mar 19, 2020 at 1:28 PM Thierry Reding <thierry.reding@xxxxxxxxx> wrote: > From: Thierry Reding <treding@xxxxxxxxxx> > > Prior to Tegra186, the selection of SFIO vs. GPIO modes was done as part > of the GPIO controller's register programming. Starting with Tegra186, a > pin is configured as GPIO or SFIO with a bit in a configuration register > of the pin controller. > > Signed-off-by: Thierry Reding <treding@xxxxxxxxxx> Patch applied! Yours, Linus Walleij
Re: [PATCH 9/9] pinctrl: tegra: Add SFIO/GPIO programming on Tegra194
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
- Subject: Re: [PATCH 9/9] pinctrl: tegra: Add SFIO/GPIO programming on Tegra194
- From: Linus Walleij <linus.walleij@xxxxxxxxxx>
- Date: Fri, 27 Mar 2020 11:46:48 +0100
- In-reply-to: <20200319122737.3063291-10-thierry.reding@gmail.com>
- References: <20200319122737.3063291-1-thierry.reding@gmail.com> <20200319122737.3063291-10-thierry.reding@gmail.com>
- References:
- [PATCH 0/9] pinctrl: tegra: Support SFIO/GPIO programming
- From: Thierry Reding
- [PATCH 9/9] pinctrl: tegra: Add SFIO/GPIO programming on Tegra194
- From: Thierry Reding
- [PATCH 0/9] pinctrl: tegra: Support SFIO/GPIO programming
- Prev by Date: Re: [PATCH 8/9] pinctrl: tegra: Renumber the GG.0 and GG.1 pins
- Next by Date: [PATCH 1/3] dt-bindings: arm: fsl-scu: Add imx8dxl pinctrl support
- Previous by thread: Re: [PATCH 9/9] pinctrl: tegra: Add SFIO/GPIO programming on Tegra194
- Next by thread: Re: [PATCH 0/9] pinctrl: tegra: Support SFIO/GPIO programming
- Index(es):
 |