Re: [PATCH v10 11/13] gpio: bd71828: Initial support for ROHM BD71828 PMIC GPIOs

[Lee Jones <lee.jones@xxxxxxxxxx>]

On Mon, 20 Jan 2020, Vaittinen, Matti wrote:

> Hello,
> 
> On Fri, 2020-01-17 at 10:21 +0000, Lee Jones wrote:
> > On Fri, 17 Jan 2020, Matti Vaittinen wrote:
> > 
> > > ROHM BD71828 PMIC contains 4 pins which can be configured by OTP
> > > to be used for general purposes. First 3 can be used as outputs
> > > and 4.th pin can be used as input. Allow them to be controlled
> > > via GPIO framework.
> > > 
> > > The driver assumes all of the pins are configured as GPIOs and
> > > trusts that the reserved pins in other OTP configurations are
> > > excluded from control using "gpio-reserved-ranges" device tree
> > > property (or left untouched by GPIO users).
> > > 
> > > Typical use for 4.th pin (input) is to use it as HALL sensor
> > > input so that this pin state is toggled when HALL sensor detects
> > > LID position change (from close to open or open to close). PMIC
> > > HW implements some extra logic which allows PMIC to power-up the
> > > system when this pin is toggled. Please see the data sheet for
> > > details of GPIO options which can be selected by OTP settings.
> > > 
> > > Signed-off-by: Matti Vaittinen <matti.vaittinen@xxxxxxxxxxxxxxxxx>
> > > Reviewed-by: Bartosz Golaszewski <bgolaszewski@xxxxxxxxxxxx>
> > > Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
> > 
> > Linus, Is that an Ack?
> I have always thought that reviewed-by implies that reviewer is Ok with
> the patch (imples Ack). Maybe I have mistaken?

I would rather not assume.

-- 
Lee Jones [李琼斯]
Linaro Services Technical Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog