Re: [PATCH] pinctrl: baytrail: Do not clear IRQ flags on direct-irq enabled pins

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sat, Dec 28, 2019 at 12:04:47AM +0100, Hans de Goede wrote:
> Suspending Goodix touchscreens requires changing the interrupt pin to
> output before sending them a power-down command. Followed by wiggling
> the interrupt pin to wake the device up, after which it is put back
> in input mode.
> 
> On Bay Trail devices with a Goodix touchscreen direct-irq mode is used
> in combination with listing the pin as a normal GpioIo resource.
> 
> This works fine, until the goodix driver gets rmmod-ed and then insmod-ed
> again. In this case byt_gpio_disable_free() calls
> byt_gpio_clear_triggering() which clears the IRQ flags and after that the
> (direct) IRQ no longer triggers.
> 
> This commit fixes this by adding a check for the BYT_DIRECT_IRQ_EN flag
> to byt_gpio_clear_triggering().
> 
> Note that byt_gpio_clear_triggering() only gets called from
> byt_gpio_disable_free() for direct-irq enabled pins, as these are excluded
> from the irq_valid mask by byt_init_irq_valid_mask().
> 
> Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>

Acked-by: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx>



[Index of Archives]     [Linux SPI]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux