[PATCH v2 07/24] pinctrl: lynxpoint: Assume 2 bits for mode selector

[Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>]

New generations can use 2 bits for mode selector.
Update the code to support it.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
 drivers/pinctrl/intel/pinctrl-lynxpoint.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/pinctrl/intel/pinctrl-lynxpoint.c b/drivers/pinctrl/intel/pinctrl-lynxpoint.c
index 17a7843c8dc9..4b2e3f298641 100644
--- a/drivers/pinctrl/intel/pinctrl-lynxpoint.c
+++ b/drivers/pinctrl/intel/pinctrl-lynxpoint.c
@@ -38,7 +38,9 @@
 #define TRIG_SEL_BIT	BIT(4) /* 0: Edge, 1: Level */
 #define INT_INV_BIT	BIT(3) /* Invert interrupt triggering */
 #define DIR_BIT		BIT(2) /* 0: Output, 1: Input */
-#define USE_SEL_BIT	BIT(0) /* 0: Native, 1: GPIO */
+#define USE_SEL_MASK	GENMASK(1, 0)	/* 0: Native, 1: GPIO, ... */
+#define USE_SEL_NATIVE	(0 << 0)
+#define USE_SEL_GPIO	(1 << 0)
 
 /* LP_CONFIG2 reg bits */
 #define GPINDIS_BIT	BIT(2) /* disable input sensing */
@@ -111,7 +113,7 @@ static int lp_gpio_request(struct gpio_chip *chip, unsigned offset)
 		return -EBUSY;
 	}
 	/* Fail if pin is in alternate function mode (not GPIO mode) */
-	if (!(inl(reg) & USE_SEL_BIT))
+	if ((inl(reg) & USE_SEL_MASK) != USE_SEL_GPIO)
 		return -ENODEV;
 
 	/* enable input sensing */
-- 
2.24.0