Re: [RFC 1/2] dt-bindings: gpio: Document shared GPIO line usage

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, Nov 20, 2019 at 2:34 PM Peter Ujfalusi <peter.ujfalusi@xxxxxx> wrote:

> Boards might use the same GPIO line to control several external devices.
> Add section to document on how a shared GPIO pin can be described.
>
> Signed-off-by: Peter Ujfalusi <peter.ujfalusi@xxxxxx>

As I've stated earlier I think this information is surplus.
If two devices have a phandle to the same GPIO line
then it is by definition shared.

> +               line_a {
> +                       gpio-shared;

So this is unnecessary: if the same line is referenced
by phandle from two places it is shared, simple as that.
It is up to code in the operating system (like Linux) to
detect if they are shared in practice (both consumer
nodes are enabled) and then deal with the outcome.

> +                       gpios = <5 0>;
> +                       output-low;

This is overlapping with the use case to define initial
state values for GPIOs, something that has been
brought up repeatedly and I've collected links for
previous discussions several times.

I guess if need be I have to look them up again.

The DT maintainers don't like the hog syntax so
something else is desired for this.

> +                       refcounted-high;
(snip)
> +The shared GPIO line management strategy can be selected with either of the
> +following properties:
> +- refcounted-low: The line must be kept low as long as there is at least one
> +               request asking it to be low.
> +- refcounted-high: The line must be kept high as long as there is at least one
> +               request asking it to be high.

Is this really needed? Isn't it more appropriate to just define the
semantics such that as soon as some consumer requests the line
high it will be refcounted high, and as soon as it is requested
low by any consumer it will be refcounted low.

> +If neither of the refcounting strategy was selected then the shared GPIO is
> +handled as pass through. In this mode all user requests will be forwarded to the
> +shared GPIO pin without refcounting.

Why should this even be allowed? If we are defining a special semantic
for refcounted GPIOs (even defining a separate API in the Linux
OS, though it is beside the point) why do we have to have a fallback
to the old behaviour at all?

I think you can do this by just detecting multiple phandles to the
same GPIO and implicit refcounting for > 1 consumers.

I.e. no new bindings at all, maybe some patches explaining the
semantic effect of using the same GPIO from two consumer
nodes.

Yours,
Linus Walleij



[Index of Archives]     [Linux SPI]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux