This makes the driver support the 'output-low' and 'output-high' devicetree properties in gpio-hog sub-nodes. Signed-off-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx> --- drivers/pinctrl/pinctrl-ingenic.c | 23 ++++++++++++++++++++++- 1 file changed, 22 insertions(+), 1 deletion(-) diff --git a/drivers/pinctrl/pinctrl-ingenic.c b/drivers/pinctrl/pinctrl-ingenic.c index 6e2683016c1f..dbd907ef7cf0 100644 --- a/drivers/pinctrl/pinctrl-ingenic.c +++ b/drivers/pinctrl/pinctrl-ingenic.c @@ -1801,19 +1801,30 @@ static void ingenic_set_bias(struct ingenic_pinctrl *jzpc, ingenic_config_pin(jzpc, pin, JZ4740_GPIO_PULL_DIS, !enabled); } +static void ingenic_set_output_level(struct ingenic_pinctrl *jzpc, + unsigned int pin, bool high) +{ + if (jzpc->version >= ID_JZ4770) + ingenic_config_pin(jzpc, pin, JZ4760_GPIO_PAT0, high); + else + ingenic_config_pin(jzpc, pin, JZ4740_GPIO_DATA, high); +} + static int ingenic_pinconf_set(struct pinctrl_dev *pctldev, unsigned int pin, unsigned long *configs, unsigned int num_configs) { struct ingenic_pinctrl *jzpc = pinctrl_dev_get_drvdata(pctldev); unsigned int idx = pin % PINS_PER_GPIO_CHIP; unsigned int offt = pin / PINS_PER_GPIO_CHIP; - unsigned int cfg; + unsigned int cfg, arg; + int ret; for (cfg = 0; cfg < num_configs; cfg++) { switch (pinconf_to_config_param(configs[cfg])) { case PIN_CONFIG_BIAS_DISABLE: case PIN_CONFIG_BIAS_PULL_UP: case PIN_CONFIG_BIAS_PULL_DOWN: + case PIN_CONFIG_OUTPUT: continue; default: return -ENOTSUPP; @@ -1821,6 +1832,8 @@ static int ingenic_pinconf_set(struct pinctrl_dev *pctldev, unsigned int pin, } for (cfg = 0; cfg < num_configs; cfg++) { + arg = pinconf_to_config_argument(configs[cfg]); + switch (pinconf_to_config_param(configs[cfg])) { case PIN_CONFIG_BIAS_DISABLE: dev_dbg(jzpc->dev, "disable pull-over for pin P%c%u\n", @@ -1844,6 +1857,14 @@ static int ingenic_pinconf_set(struct pinctrl_dev *pctldev, unsigned int pin, ingenic_set_bias(jzpc, pin, true); break; + case PIN_CONFIG_OUTPUT: + ret = pinctrl_gpio_direction_output(pin); + if (ret) + return ret; + + ingenic_set_output_level(jzpc, pin, arg); + break; + default: unreachable(); } -- 2.24.0