Re: [PATCH 08/12] drivers: pinctrl: msm: setup GPIO chip in hierarchy

[Stephen Boyd <swboyd@xxxxxxxxxxxx>]

Quoting Lina Iyer (2019-11-15 13:57:37)
> On Fri, Nov 15 2019 at 13:55 -0700, Lina Iyer wrote:
> >>Quoting Lina Iyer (2019-11-14 10:35:17)
> 
> >>>+static int msm_gpio_wakeirq(struct gpio_chip *gc,
> >>>+                           unsigned int child,
> >>>+                           unsigned int child_type,
> >>>+                           unsigned int *parent,
> >>>+                           unsigned int *parent_type)
> >>>+{
> >>>+       struct msm_pinctrl *pctrl = gpiochip_get_data(gc);
> >>>+       const struct msm_gpio_wakeirq_map *map;
> >>>+       int i;
> >>>+
> >>>+       *parent = GPIO_NO_WAKE_IRQ;
> >>>+       *parent_type = IRQ_TYPE_EDGE_RISING;
> >>>+
> >>>+       for (i = 0; i < pctrl->soc->nwakeirq_map; i++) {
> >>>+               map = &pctrl->soc->wakeirq_map[i];
> >>>+               if (map->gpio == child) {
> >>>+                       *parent = map->wakeirq;
> >>>+                       break;
> >>>+               }
> >>>+       }
> >>>+
> >>>+       return 0;
> >>
> >>Shouldn't we return -EINVAL if we can't translate the gpio irq to the
> >>parent domain? I would expect to see return -EINVAL here and the above
> >>if condition to return 0 instead of break.
> >>
> >Good catch. Sure.
> >>>+}
> >>>+
> Looking into this, we have been setting GPIO in hierarchy with PDC and
> the return 0 is appropriate as it would set the GPIO_NO_WAKE_IRQ as the
> parent and setup the IRQ correctly. We fail to setup GPIOs otherwise.

Ah ok so by default we will set the parent irq to ~0 and that means
bypass pdc and go directly to GIC?

Where do we fail to setup a GPIO otherwise? It sounds like we can always
translate to either something in the map or to ~0.