Re: [PATCH 0/4] SPMI GPIOs and MPPs on PM/PMI8950

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

On Thu, Oct 31, 2019 at 11:35 AM <kholk11@xxxxxxxxx> wrote:

> From: AngeloGioacchino Del Regno <kholk11@xxxxxxxxx>
>
> This patch series enables support for GPIOs and MPPs found on the
> PM8950 and PMI8950 ICs, usually found on boards using the MSM8956,
> MSM8976, MSM8952, MSM8953 (and APQ variants) SoC.
>
> These are important to get the PA_THERM, QUIET_THERM MPPs enabled
> on PM8950 for standard thermals (and other board specific ones,
> where applicable) and GPIOs usually used to enable the audio mclk
> path, the wlan sleep clock and sometimes the eLDO for the WCD codec,
> plus other board specific paths, where applicable.
> For example, on the MSM8956 Sony Xperia Loire platform, this also
> includes a GPIO for the USB switch and one for the simple GPIO
> controlled vibrator included in all devices for this series of
> boards.
>
> This has been tested on Sony Xperia Loire phones, including the
> Xperia X Compact (Kugo) and Xperia X (Suzu).
>
> AngeloGioacchino Del Regno (4):
>   pinctrl: qcom: spmi-gpio: Add PM/PMI8950 compatibility
>   dt-bindings: pinctrl: qcom-pmic-gpio: Add support for PM/PMI8950
>   pinctrl: qcom: spmi-mpp: Add PM/PMI8950 compatible strings
>   dt-bindings: pinctrl: qcom-pmic-mpp: Add support for PM/PMI8950

These patches seem very simple and straight-forward and
noncontroversial so I just applied them.

Stakeholders can complain if they think otherwise.

Yours,
Linus Walleij