t's hard for occasional GPIO code reader/writer to know if values 0/1 equal to IN or OUT. Use defined GPIO_LINE_DIRECTION_IN and GPIO_LINE_DIRECTION_OUT to help them out. Signed-off-by: Matti Vaittinen <matti.vaittinen@xxxxxxxxxxxxxxxxx> --- drivers/gpio/gpio-bcm-kona.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/gpio/gpio-bcm-kona.c b/drivers/gpio/gpio-bcm-kona.c index 9fa6d3a967d2..4122683eb1f9 100644 --- a/drivers/gpio/gpio-bcm-kona.c +++ b/drivers/gpio/gpio-bcm-kona.c @@ -127,7 +127,7 @@ static int bcm_kona_gpio_get_dir(struct gpio_chip *chip, unsigned gpio) u32 val; val = readl(reg_base + GPIO_CONTROL(gpio)) & GPIO_GPCTR0_IOTR_MASK; - return !!val; + return val ? GPIO_LINE_DIRECTION_IN : GPIO_LINE_DIRECTION_OUT; } static void bcm_kona_gpio_set(struct gpio_chip *chip, unsigned gpio, int value) @@ -144,7 +144,7 @@ static void bcm_kona_gpio_set(struct gpio_chip *chip, unsigned gpio, int value) raw_spin_lock_irqsave(&kona_gpio->lock, flags); /* this function only applies to output pin */ - if (bcm_kona_gpio_get_dir(chip, gpio) == 1) + if (bcm_kona_gpio_get_dir(chip, gpio) == GPIO_LINE_DIRECTION_IN) goto out; reg_offset = value ? GPIO_OUT_SET(bank_id) : GPIO_OUT_CLEAR(bank_id); @@ -170,7 +170,7 @@ static int bcm_kona_gpio_get(struct gpio_chip *chip, unsigned gpio) reg_base = kona_gpio->reg_base; raw_spin_lock_irqsave(&kona_gpio->lock, flags); - if (bcm_kona_gpio_get_dir(chip, gpio) == 1) + if (bcm_kona_gpio_get_dir(chip, gpio) == GPIO_LINE_DIRECTION_IN) reg_offset = GPIO_IN_STATUS(bank_id); else reg_offset = GPIO_OUT_STATUS(bank_id); -- 2.21.0 -- Matti Vaittinen, Linux device drivers ROHM Semiconductors, Finland SWDC Kiviharjunlenkki 1E 90220 OULU FINLAND ~~~ "I don't think so," said Rene Descartes. Just then he vanished ~~~ Simon says - in Latin please. ~~~ "non cogito me" dixit Rene Descarte, deinde evanescavit ~~~ Thanks to Simon Glass for the translation =]