On Wed, Jun 26, 2019 at 10:44:05AM +0200, Linus Walleij wrote: > We need to convert all old gpio irqchips to pass the irqchip > setup along when adding the gpio_chip. > > For chained irqchips this is a pretty straight-forward > conversion. > > Cc: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx> > Cc: Thierry Reding <treding@xxxxxxxxxx> > Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx> > --- > ChangeLog v1->v2: > - Split out bugfixes to separate patches. > --- > drivers/gpio/gpio-siox.c | 14 +++++++------- > 1 file changed, 7 insertions(+), 7 deletions(-) > > diff --git a/drivers/gpio/gpio-siox.c b/drivers/gpio/gpio-siox.c > index 40067e1535d3..31749c058e33 100644 > --- a/drivers/gpio/gpio-siox.c > +++ b/drivers/gpio/gpio-siox.c > @@ -211,6 +211,7 @@ static int gpio_siox_get_direction(struct gpio_chip *chip, unsigned int offset) > static int gpio_siox_probe(struct siox_device *sdevice) > { > struct gpio_siox_ddata *ddata; > + struct gpio_irq_chip *girq; > int ret; > > ddata = devm_kzalloc(&sdevice->dev, sizeof(*ddata), GFP_KERNEL); > @@ -239,6 +240,11 @@ static int gpio_siox_probe(struct siox_device *sdevice) > ddata->ichip.irq_unmask = gpio_siox_irq_unmask; > ddata->ichip.irq_set_type = gpio_siox_irq_set_type; > > + girq = &ddata->gchip.irq; > + girq->chip = &ddata->ichip; > + girq->default_type = IRQ_TYPE_NONE; > + girq->handler = handle_level_irq; > + > ret = gpiochip_add(&ddata->gchip); > if (ret) { > dev_err(&sdevice->dev, > @@ -246,13 +252,7 @@ static int gpio_siox_probe(struct siox_device *sdevice) > return ret; > } > > - ret = gpiochip_irqchip_add(&ddata->gchip, &ddata->ichip, > - 0, handle_level_irq, IRQ_TYPE_NONE); > - if (ret) > - dev_err(&sdevice->dev, > - "Failed to register irq chip (%d)\n", ret); > - > - return ret; > + return 0; > } You can simplify this a bit further from: if (ret) { ... return ret; } return 0; to if (ret) { ... } return ret; Best regards Uwe -- Pengutronix e.K. | Uwe Kleine-König | Industrial Linux Solutions | http://www.pengutronix.de/ |