[PATCH 2/5] gpio: siox: Switch to IRQ_TYPE_NONE

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

The siox driver is hardcoding a default type of
IRQ_TYPE_EDGE_RISING to the irq helper, but this should only
be applicable to old boardfiles and odd device tree irqchips
with just onecell irq (no flags). I doubt this is the case
with the siox, I think all consumers specify the flags they
use in the device tree.

Cc: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx>
Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
---
 drivers/gpio/gpio-siox.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/gpio/gpio-siox.c b/drivers/gpio/gpio-siox.c
index 0b4450118865..40067e1535d3 100644
--- a/drivers/gpio/gpio-siox.c
+++ b/drivers/gpio/gpio-siox.c
@@ -247,7 +247,7 @@ static int gpio_siox_probe(struct siox_device *sdevice)
 	}
 
 	ret = gpiochip_irqchip_add(&ddata->gchip, &ddata->ichip,
-				   0, handle_level_irq, IRQ_TYPE_EDGE_RISING);
+				   0, handle_level_irq, IRQ_TYPE_NONE);
 	if (ret)
 		dev_err(&sdevice->dev,
 			"Failed to register irq chip (%d)\n", ret);
-- 
2.20.1