Re: [PATCH 0/6] pinctrl: sunxi: Allow to configure pull-up / pull-down from GPIO flags

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Mar 14, 2019 at 08:32:49PM +0100, Maxime Ripard wrote:
> Hi,
>
> Here is a series that addresses one of the issues we've had for some time
> with our pinctrl driver, which is that while we should have had the strict
> mode enabled, we didn't and now we have to deal with all the DT having GPIO
> and pinctrl nodes for the same pins.
>
> This was partially due to cargo cult (which has been addressed since), but
> also due to technical limitations of the GPIO DT bindings at the time which
> didn't allow to specify the pull-up and pull-down resistors, and the drive
> strength of the pins.
>
> Now that the former are supported, we can remove those users, and we will
> deal with the latter eventually.
>
> Let me know what you think,
> Maxime

Applied 5 and 6, thanks!
Maxime

--
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com

Attachment: signature.asc
Description: PGP signature


[Index of Archives]     [Linux SPI]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux