Re: [PATCH v7 6/6] pinctrl: lochnagar: Add support for the Cirrus Logic Lochnagar

[Charles Keepax <ckeepax@xxxxxxxxxxxxxxxxxxxxx>]

On Wed, Jan 30, 2019 at 11:41:28AM +0000, Charles Keepax wrote:
> Lochnagar is an evaluation and development board for Cirrus
> Logic Smart CODEC and Amp devices. It allows the connection of
> most Cirrus Logic devices on mini-cards, as well as allowing
> connection of various application processor systems to provide a
> full evaluation platform. This driver supports the board
> controller chip on the Lochnagar board.
> 
> Lochnagar provides many pins which can generally be used for an
> audio function such as an AIF or a PDM interface, but also as
> GPIOs.
> 
> Signed-off-by: Charles Keepax <ckeepax@xxxxxxxxxxxxxxxxxxxxx>
> Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
> ---
> 
> No changes since v6.
> 
> Thanks,
> Charles
> 
>  drivers/pinctrl/cirrus/Kconfig             |   10 +
>  drivers/pinctrl/cirrus/Makefile            |    2 +
>  drivers/pinctrl/cirrus/pinctrl-lochnagar.c | 1236 ++++++++++++++++++++++++++++
>  3 files changed, 1248 insertions(+)
>  create mode 100644 drivers/pinctrl/cirrus/pinctrl-lochnagar.c
> 
> +LN2_PIN_MUX(FPGA_GPIO1,    "fgpa-gpio1");
> +LN2_PIN_MUX(FPGA_GPIO2,    "fgpa-gpio2");
> +LN2_PIN_MUX(FPGA_GPIO3,    "fgpa-gpio3");
> +LN2_PIN_MUX(FPGA_GPIO4,    "fgpa-gpio4");
> +LN2_PIN_MUX(FPGA_GPIO5,    "fgpa-gpio5");
> +LN2_PIN_MUX(FPGA_GPIO6,    "fgpa-gpio6");

Apologies for this late spot but there is typo here, these should
of course read fpga not fgpa. I will resend, going to start
sending the sub drivers separately now, since Lee has merged the
MFD cut down on the email traffic for everyone a little.

Thanks,
Charles