spmi-gpio did not have any irqchip support so consumers of this in device tree would need to call gpio[d]_to_irq() in order to get the proper IRQ on the underlying PMIC. IRQ chips in device tree should be usable from the start without the consumer having to make an additional call to get the proper IRQ on the parent. This patch adds hierarchical IRQ chip support to the spmi-gpio code to correct this issue. Driver was tested using the volume buttons (via gpio-keys) on the LG Nexus 5 (hammerhead) phone with the following two configurations. volume-up { interrupts-extended = <&pm8941_gpios 2 IRQ_TYPE_EDGE_BOTH>; ... }; volume-up { gpios = <&pm8941_gpios 2 GPIO_ACTIVE_LOW>; ... }; Both configurations now show that spmi-gpio is the IRQ domain and that the IRQ is setup in a hierarchy. $ grep volume_up /proc/interrupts 72: 6 0 spmi-gpio 1 Edge volume_up $ cat /sys/kernel/debug/irq/irqs/72 handler: handle_edge_irq device: (null) status: 0x00000403 _IRQ_NOPROBE istate: 0x00000000 ddepth: 0 wdepth: 0 dstate: 0x02400203 IRQ_TYPE_EDGE_RISING IRQ_TYPE_EDGE_FALLING IRQD_ACTIVATED IRQD_IRQ_STARTED node: 0 affinity: 0-3 effectiv: domain: :soc:spmi@fc4cf000:pm8941@0:gpios@c000 hwirq: 0x1 chip: spmi-gpio flags: 0x4 IRQCHIP_MASK_ON_SUSPEND parent: domain: :soc:spmi@fc4cf000 hwirq: 0xc100057 chip: pmic_arb flags: 0x4 IRQCHIP_MASK_ON_SUSPEND Signed-off-by: Brian Masney <masneyb@xxxxxxxxxxxxx> Reviewed-by: Stephen Boyd <sboyd@xxxxxxxxxx> --- Changes since v5: - Change IRQ_TYPE_NONE to IRQ_TYPE_EDGE_RISING Changes since v4: - None Changes since v3: - None Changes since v2: - Use PMIC_GPIO_PHYSICAL_OFFSET instead of the 1 constant - Use gpiochip_irq_domain_{activate,deactivate} - Changed 'fwspec->param[0] + 0xc0 - 1' to 'hwirq + c0' in call to irq_domain_alloc_irqs_parent Changes since v1: - Use two cells for interrupts instead of four. - Pin numbers in interrupts-extended are now one based instead of zero based so that they match the GPIO pin number. - Drop unnecessary parenthesis in pmic_gpio_domain_translate - Add missing of_node_put() - Remove irq field from pmic_gpio_pad struct that is no longer necessary. drivers/pinctrl/qcom/pinctrl-spmi-gpio.c | 115 +++++++++++++++++++++-- 1 file changed, 105 insertions(+), 10 deletions(-) diff --git a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c index b6fa2c7dbb26..e01a556ac586 100644 --- a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c +++ b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c @@ -12,6 +12,7 @@ */ #include <linux/gpio/driver.h> +#include <linux/interrupt.h> #include <linux/module.h> #include <linux/of.h> #include <linux/of_irq.h> @@ -136,7 +137,6 @@ enum pmic_gpio_func_index { /** * struct pmic_gpio_pad - keep current GPIO settings * @base: Address base in SPMI device. - * @irq: IRQ number which this GPIO generate. * @is_enabled: Set to false when GPIO should be put in high Z state. * @out_value: Cached pin output value * @have_buffer: Set to true if GPIO output could be configured in push-pull, @@ -156,7 +156,6 @@ enum pmic_gpio_func_index { */ struct pmic_gpio_pad { u16 base; - int irq; bool is_enabled; bool out_value; bool have_buffer; @@ -179,6 +178,8 @@ struct pmic_gpio_state { struct regmap *map; struct pinctrl_dev *ctrl; struct gpio_chip chip; + struct fwnode_handle *fwnode; + struct irq_domain *domain; }; static const struct pinconf_generic_params pmic_gpio_bindings[] = { @@ -761,11 +762,18 @@ static int pmic_gpio_of_xlate(struct gpio_chip *chip, static int pmic_gpio_to_irq(struct gpio_chip *chip, unsigned pin) { struct pmic_gpio_state *state = gpiochip_get_data(chip); - struct pmic_gpio_pad *pad; + struct irq_fwspec fwspec; - pad = state->ctrl->desc->pins[pin].drv_data; + fwspec.fwnode = state->fwnode; + fwspec.param_count = 2; + fwspec.param[0] = pin + PMIC_GPIO_PHYSICAL_OFFSET; + /* + * Set the type to a safe value temporarily. This will be overwritten + * later with the proper value by irq_set_type. + */ + fwspec.param[1] = IRQ_TYPE_EDGE_RISING; - return pad->irq; + return irq_create_fwspec_mapping(&fwspec); } static void pmic_gpio_dbg_show(struct seq_file *s, struct gpio_chip *chip) @@ -935,8 +943,78 @@ static int pmic_gpio_populate(struct pmic_gpio_state *state, return 0; } +static struct irq_chip pmic_gpio_irq_chip = { + .name = "spmi-gpio", + .irq_ack = irq_chip_ack_parent, + .irq_mask = irq_chip_mask_parent, + .irq_unmask = irq_chip_unmask_parent, + .irq_set_type = irq_chip_set_type_parent, + .irq_set_wake = irq_chip_set_wake_parent, + .flags = IRQCHIP_MASK_ON_SUSPEND, +}; + +static int pmic_gpio_domain_translate(struct irq_domain *domain, + struct irq_fwspec *fwspec, + unsigned long *hwirq, + unsigned int *type) +{ + struct pmic_gpio_state *state = container_of(domain->host_data, + struct pmic_gpio_state, + chip); + + if (fwspec->param_count != 2 || fwspec->param[0] >= state->chip.ngpio) + return -EINVAL; + + *hwirq = fwspec->param[0] - PMIC_GPIO_PHYSICAL_OFFSET; + *type = fwspec->param[1]; + + return 0; +} + +static int pmic_gpio_domain_alloc(struct irq_domain *domain, unsigned int virq, + unsigned int nr_irqs, void *data) +{ + struct pmic_gpio_state *state = container_of(domain->host_data, + struct pmic_gpio_state, + chip); + struct irq_fwspec *fwspec = data; + struct irq_fwspec parent_fwspec; + irq_hw_number_t hwirq; + unsigned int type; + int ret, i; + + ret = pmic_gpio_domain_translate(domain, fwspec, &hwirq, &type); + if (ret) + return ret; + + for (i = 0; i < nr_irqs; i++) + irq_domain_set_info(domain, virq + i, hwirq + i, + &pmic_gpio_irq_chip, state, + handle_level_irq, NULL, NULL); + + parent_fwspec.fwnode = domain->parent->fwnode; + parent_fwspec.param_count = 4; + parent_fwspec.param[0] = 0; + parent_fwspec.param[1] = hwirq + 0xc0; + parent_fwspec.param[2] = 0; + parent_fwspec.param[3] = fwspec->param[1]; + + return irq_domain_alloc_irqs_parent(domain, virq, nr_irqs, + &parent_fwspec); +} + +static const struct irq_domain_ops pmic_gpio_domain_ops = { + .activate = gpiochip_irq_domain_activate, + .alloc = pmic_gpio_domain_alloc, + .deactivate = gpiochip_irq_domain_deactivate, + .free = irq_domain_free_irqs_common, + .translate = pmic_gpio_domain_translate, +}; + static int pmic_gpio_probe(struct platform_device *pdev) { + struct irq_domain *parent_domain; + struct device_node *parent_node; struct device *dev = &pdev->dev; struct pinctrl_pin_desc *pindesc; struct pinctrl_desc *pctrldesc; @@ -993,10 +1071,6 @@ static int pmic_gpio_probe(struct platform_device *pdev) pindesc->number = i; pindesc->name = pmic_gpio_groups[i]; - pad->irq = platform_get_irq(pdev, i); - if (pad->irq < 0) - return pad->irq; - pad->base = reg + i * PMIC_GPIO_ADDRESS_RANGE; ret = pmic_gpio_populate(state, pad); @@ -1016,10 +1090,28 @@ static int pmic_gpio_probe(struct platform_device *pdev) if (IS_ERR(state->ctrl)) return PTR_ERR(state->ctrl); + parent_node = of_irq_find_parent(state->dev->of_node); + if (!parent_node) + return -ENXIO; + + parent_domain = irq_find_host(parent_node); + of_node_put(parent_node); + if (!parent_domain) + return -ENXIO; + + state->fwnode = of_node_to_fwnode(state->dev->of_node); + state->domain = irq_domain_create_hierarchy(parent_domain, 0, + state->chip.ngpio, + state->fwnode, + &pmic_gpio_domain_ops, + &state->chip); + if (!state->domain) + return -ENODEV; + ret = gpiochip_add_data(&state->chip, state); if (ret) { dev_err(state->dev, "can't add gpio chip\n"); - return ret; + goto err_chip_add_data; } /* @@ -1045,6 +1137,8 @@ static int pmic_gpio_probe(struct platform_device *pdev) err_range: gpiochip_remove(&state->chip); +err_chip_add_data: + irq_domain_remove(state->domain); return ret; } @@ -1053,6 +1147,7 @@ static int pmic_gpio_remove(struct platform_device *pdev) struct pmic_gpio_state *state = platform_get_drvdata(pdev); gpiochip_remove(&state->chip); + irq_domain_remove(state->domain); return 0; } -- 2.17.2