Re: [PATCH v3 4/6] qcom: spmi-gpio: add support for hierarchical IRQ chip

[Stephen Boyd <sboyd@xxxxxxxxxx>]

Quoting Brian Masney (2019-01-09 17:12:56)
> spmi-gpio did not have any irqchip support so consumers of this in
> device tree would need to call gpio[d]_to_irq() in order to get the
> proper IRQ on the underlying PMIC. IRQ chips in device tree should
> be usable from the start without the consumer having to make an
> additional call to get the proper IRQ on the parent. This patch adds
> hierarchical IRQ chip support to the spmi-gpio code to correct this
> issue.
> 
> Driver was tested using the volume buttons (via gpio-keys) on the LG
> Nexus 5 (hammerhead) phone with the following two configurations.
> 
> volume-up {
>         interrupts-extended = <&pm8941_gpios 2 IRQ_TYPE_EDGE_BOTH>;
>         ...
> };
> 
> volume-up {
>         gpios = <&pm8941_gpios 2 GPIO_ACTIVE_LOW>;
>         ...
> };
> 
> Both configurations now show that spmi-gpio is the IRQ domain and that
> the IRQ is setup in a hierarchy.
> 
> $ grep volume_up /proc/interrupts
>  72:          6          0  spmi-gpio   1 Edge      volume_up
> 
> $ cat /sys/kernel/debug/irq/irqs/72
> handler:  handle_edge_irq
> device:   (null)
> status:   0x00000403
>             _IRQ_NOPROBE
> istate:   0x00000000
> ddepth:   0
> wdepth:   0
> dstate:   0x02400203
>             IRQ_TYPE_EDGE_RISING
>             IRQ_TYPE_EDGE_FALLING
>             IRQD_ACTIVATED
>             IRQD_IRQ_STARTED
> node:     0
> affinity: 0-3
> effectiv: 
> domain:  :soc:spmi@fc4cf000:pm8941@0:gpios@c000
>  hwirq:   0x1
>  chip:    spmi-gpio
>   flags:   0x4
>              IRQCHIP_MASK_ON_SUSPEND
>  parent:
>     domain:  :soc:spmi@fc4cf000
>      hwirq:   0xc100057
>      chip:    pmic_arb
>       flags:   0x4
>                  IRQCHIP_MASK_ON_SUSPEND
> 
> Signed-off-by: Brian Masney <masneyb@xxxxxxxxxxxxx>
> ---

Reviewed-by: Stephen Boyd <sboyd@xxxxxxxxxx>