[PATCH 5/7 v2] spi: clps711x: Convert to use CS GPIO descriptors

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

This converts the CLPS711x SPI master driver to use GPIO
descriptors for chip select handling.

The CLPS711x driver was merely requesting the GPIO and
setting the CS line non-asserted so this was a pretty
straight-forward conversion. The setup callback goes away.

Cc: Alexander Shiyan <shc_work@xxxxxxx>
Cc: Linuxarm <linuxarm@xxxxxxxxxx>
Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
---
ChangeLog v1->v2:
- Rebase on v5.0-rc1
---
 drivers/spi/spi-clps711x.c | 23 ++---------------------
 1 file changed, 2 insertions(+), 21 deletions(-)

diff --git a/drivers/spi/spi-clps711x.c b/drivers/spi/spi-clps711x.c
index 18193df2eba8..8c03c409fc07 100644
--- a/drivers/spi/spi-clps711x.c
+++ b/drivers/spi/spi-clps711x.c
@@ -11,7 +11,7 @@
 
 #include <linux/io.h>
 #include <linux/clk.h>
-#include <linux/gpio.h>
+#include <linux/gpio/consumer.h>
 #include <linux/module.h>
 #include <linux/interrupt.h>
 #include <linux/platform_device.h>
@@ -36,25 +36,6 @@ struct spi_clps711x_data {
 	int			len;
 };
 
-static int spi_clps711x_setup(struct spi_device *spi)
-{
-	if (!spi->controller_state) {
-		int ret;
-
-		ret = devm_gpio_request(&spi->master->dev, spi->cs_gpio,
-					dev_name(&spi->master->dev));
-		if (ret)
-			return ret;
-
-		spi->controller_state = spi;
-	}
-
-	/* We are expect that SPI-device is not selected */
-	gpio_direction_output(spi->cs_gpio, !(spi->mode & SPI_CS_HIGH));
-
-	return 0;
-}
-
 static int spi_clps711x_prepare_message(struct spi_master *master,
 					struct spi_message *msg)
 {
@@ -125,11 +106,11 @@ static int spi_clps711x_probe(struct platform_device *pdev)
 	if (!master)
 		return -ENOMEM;
 
+	master->use_gpio_descriptors = true;
 	master->bus_num = -1;
 	master->mode_bits = SPI_CPHA | SPI_CS_HIGH;
 	master->bits_per_word_mask =  SPI_BPW_RANGE_MASK(1, 8);
 	master->dev.of_node = pdev->dev.of_node;
-	master->setup = spi_clps711x_setup;
 	master->prepare_message = spi_clps711x_prepare_message;
 	master->transfer_one = spi_clps711x_transfer_one;
 
-- 
2.19.2