On Mon, Dec 17, 2018 at 9:43 AM Uwe Kleine-König
<u.kleine-koenig@xxxxxxxxxxxxxx> wrote:
> The gpio IP on Armada 370 at offset 0x18180 has neither a clk nor pwm
> registers. So there is no need for a clk as the pwm isn't used anyhow.
> So only check for the clk in the presence of the pwm registers. This fixes
> a failure to probe the gpio driver for the above mentioned gpio device.
>
> Fixes: 757642f9a584 ("gpio: mvebu: Add limited PWM support")
> Signed-off-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx>
Patch applied for fixes with Gregory's review tag!
Will try to get this upstream with some other GPIO
fixes ASAP.
Yours,
Linus Walleij
Re: [PATCH] gpio: mvebu: only fail on missing clk if pwm is actually to be used
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
- Subject: Re: [PATCH] gpio: mvebu: only fail on missing clk if pwm is actually to be used
- From: Linus Walleij <linus.walleij@xxxxxxxxxx>
- Date: Mon, 17 Dec 2018 15:25:56 +0100
- In-reply-to: <20181217084313.15379-1-u.kleine-koenig@pengutronix.de>
- References: <20181217084313.15379-1-u.kleine-koenig@pengutronix.de>
- References:
- [PATCH] gpio: mvebu: only fail on missing clk if pwm is actually to be used
- From: Uwe Kleine-König
- [PATCH] gpio: mvebu: only fail on missing clk if pwm is actually to be used
- Prev by Date: Re: [PATCH 07/15] pinctrl: sh-pfc: sh7264: Fix PFCR3 and PFCR0 register configuration
- Next by Date: Re: [PATCH] gpio: rcar: select General Output Register to set output states
- Previous by thread: Re: [PATCH] gpio: mvebu: only fail on missing clk if pwm is actually to be used
- Next by thread: [PATCH] memory: omap-gpmc: Get the header of the enum
- Index(es):
 |