Re: [PATCH 2/2] gpio: mockup: use irq_sim_fire_edge()

[Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx>]

Hello Bartosz,

On Mon, Dec 03, 2018 at 12:09:16PM +0100, Uwe Kleine-König wrote:
> On Tue, Nov 20, 2018 at 02:40:32PM +0100, Bartosz Golaszewski wrote:
> > @@ -213,7 +213,8 @@ static ssize_t gpio_mockup_event_write(struct file *file,
> >  	chip = priv->chip;
> >  
> >  	gpiod_set_value_cansleep(desc, val);
> > -	irq_sim_fire(&chip->irqsim, priv->offset);
> > +	edge = val == 0 ? IRQ_TYPE_EDGE_FALLING : IRQ_TYPE_EDGE_RISING;
> > +	irq_sim_fire_edge(&chip->irqsim, priv->offset, edge);
> 
> If I write 0 twice into the debugfs file, does it fire two irqs or only
> one? I think it fires two but only one would be the right behaviour?!

If you still think that patch 1 of this series is the way to go, I think
this objection is still valid. Then you need to check the state of the
line by at least calling (something like) .get_value to determine if the
previous value was different.

Best regards
Uwe

-- 
Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |