Re: [PATCH 2/2] gpio: mt7621: pass mediatek_gpio_bank_probe() failure up the stack

[Sean Wang <sean.wang@xxxxxxxxxx>]

>
> On Mon, Nov 26, 2018 at 11:49:26PM -0800, Sean Wang wrote:
> > Nicholas Mc Guire <hofrat@xxxxxxxxx> ??? 2018???11???21??? ?????? ??????10:13?????????
> > >
> > > The error cases of mediatek_gpio_bank_probe() would go unnoticed (except
> > > for the dev_err() messages). The probe function should return an error
> > > if one of the banks failed to initialize properly.
> > >
> > > Signed-off-by: Nicholas Mc Guire <hofrat@xxxxxxxxx>
> > > Fixes: 4ba9c3afda41 ("gpio: mt7621: Add a driver for MT7621")
> > > ---
> > >
> > > Patch was compile tested with: omega2p_defconfig, SOC_MT7621=y,
> > > GPIOLIB=y, GPIO_MT7621=y
> > >
> > > Patch is against 4.20-rc3 (localversion-next is next-20181121)
> > >
> > >  drivers/gpio/gpio-mt7621.c | 8 ++++++--
> > >  1 file changed, 6 insertions(+), 2 deletions(-)
> > >
> > > diff --git a/drivers/gpio/gpio-mt7621.c b/drivers/gpio/gpio-mt7621.c
> > > index 1ec95bc..68fca8b 100644
> > > --- a/drivers/gpio/gpio-mt7621.c
> > > +++ b/drivers/gpio/gpio-mt7621.c
> > > @@ -297,6 +297,7 @@ mediatek_gpio_probe(struct platform_device *pdev)
> > >         struct device_node *np = dev->of_node;
> > >         struct mtk *mtk;
> > >         int i;
> > > +       int ret;
> > >
> > >         mtk = devm_kzalloc(dev, sizeof(*mtk), GFP_KERNEL);
> > >         if (!mtk)
> > > @@ -311,8 +312,11 @@ mediatek_gpio_probe(struct platform_device *pdev)
> > >         platform_set_drvdata(pdev, mtk);
> > >         mediatek_gpio_irq_chip.name = dev_name(dev);
> > >
> > > -       for (i = 0; i < MTK_BANK_CNT; i++)
> > > -               mediatek_gpio_bank_probe(dev, np, i);
> > > +       for (i = 0; i < MTK_BANK_CNT; i++) {
> > > +               ret = mediatek_gpio_bank_probe(dev, np, i);
> > > +               if (!ret)
> >
> > it should be if (ret < 0) ?
>
> I don´t think so mediatek_gpio_bank_probe() returns 0 on success
> and all other returns are error paths - while the current code
> only returns negative values I do thik that any non 0 would be
> an error indication so !ret should be fine here.
>
!0 would be true

> thx!
> hofrat
>
> >
> > > +                       return ret;
> > > +       }
> > >
> > >         return 0;
> > >  }
> > > --
> > > 2.1.4
> > >
> > >
> > > _______________________________________________
> > > Linux-mediatek mailing list
> > > Linux-mediatek@xxxxxxxxxxxxxxxxxxx
> > > http://lists.infradead.org/mailman/listinfo/linux-mediatek
>
> _______________________________________________
> Linux-mediatek mailing list
> Linux-mediatek@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-mediatek