On Mon, Oct 08, 2018 at 03:28:01PM +0000, Leonard Crestez wrote: > Bindings for "fixed-regulator" only explicitly support "gpio" property, > not "gpios". Fix by correcting the property name. > > The enet PHYs on imx6sx-sdb needs to be explicitly reset after a power > cycle, this can be handled by the phy-reset-gpios property. Sadly this > is not handled on suspend: the fec driver turns phy-supply off but > doesn't assert phy-reset-gpios again on resume. > > Since additional phy-level work is required to support powering off the > phy in suspend fix the problem by just marking the regulator as > "boot-on" "always-on" so that it's never turned off. This behavior is > equivalent to older releases. > > Keep the phy-reset-gpios property on fec anyway because it is a correct > description of board design. > > This issue was exposed by commit efdfeb079cc3 ("regulator: fixed: > Convert to use GPIO descriptor only") which causes the "gpios" property > to also be parsed. Before that commit the "gpios" property had no > effect, PHY reset was only handled in the the bootloader. > > This fixes linux-next boot failures previously reported here: > https://lore.kernel.org/patchwork/patch/982437/#1177900 > https://lore.kernel.org/patchwork/patch/994091/#1178304 > > Signed-off-by: Leonard Crestez <leonard.crestez@xxxxxxx> Applied, thanks.